User manual GRUNDIG CDP 410

[. . . ] · You can clean the CD player cabinet with a soft and slightly dampened chamois leather. Do not use any cleaning agents as they may have a corrosive effect. · The lens may cloud over when the set is suddenly moved from cold to warm surroundings. Leave the CD player in a warm environment until the moisture evaporates. [. . . ] Note: The battery supply is switched off when the DC IN 6. 0 V socket is in use. When changing over to battery supply, pull out the plug from the DC IN 6. 0 V socket. DAS TRACK MIN SEC Mains adapter (supplied) 1 Make sure that the local voltage corresponds to the voltage of the adapter. 2 Connect the supplied mains adapter (6. 0 V/450 mA Direct Current plus-pole to the centre pin) to the player's DC IN 6. 0 V jack and to the wall outlet. · Always disconnect the adapter if you are not using it. Note: The CD-player remains connected to the mains even when it is switched off. The unit is only fully isolated from the mains if the mains adapter is removed from the wall socket. 12 Note on Environmental Protection Do not throw exhausted batteries in the household refuse. Hand over the old batteries to your dealer or public collecting points when buying new ones. Line out DC IN -<+ 6. 0 V T OU E LIN E LIN T OU (AUX, LINE IN) CD IN LINE OUT Reproduction through a stereo system · Turn down the volume of your stereo system. · Connect a signal lead to the LINE OUT jack of the CD player and to the input jacks CD IN, AUX(iliary) or LINE IN of the other set (amplifier, receiver, radio cassette recorder etc. ). · Adjust the sound with the controls of the stereo system. CDP 410/440 page 13 CD PLAYER Inserting a CD · · · · Open the lid by sliding the OPEN button and lifting the lid gently. Push gently on the CD center so that it fits onto the hub. In addition to standard 12 cm CD's, you can also play 8 cm CD singles without an adapter. · Close the lid by pushing it gently on its right-hand side. ­ The CD-player scans the contents list of the CD. The total playing time and the total number of tracks appear on the display. · Press 2; PLAY/PAUSE to start playback. Removing the CD: · Open the CD door only if the CD player is in position STOP. · To take out the CD, open the CD lid by sliding the OPEN switch and lifting the lid gently. · Hold the CD by its edge and press the hub gently. Automatic Power-Off This CD-player is equipped with an automatic power-off function. · In STOP mode, the player automatically shuts down approximately 30 seconds after the last operation. · If you press STOP while the set is in STOP mode, the player also shuts down. · To reactivate the player, press 2; PLAY/PAUSE. DAS TRACK MIN SEC GB SEARCH / SKIP Selecting another track during play · Press SEARCH S or SKIP T until the required track number appears in the display. [. . . ] If you exceed the maximum of 20 tracks, the programme function will start again from the beginning. You may store each track more than once. Storing a programme · Insert a CD and close the compartment. · Press the PLAY·PAUSE 2; button to read the CD. [. . . ]