User manual GRUNDIG GV 600 SV

[. . . ] VIDEORECORDER GV 600 SV Inserting batteries into the remote control . 6 The two levels of the remote control . 6-7 Programming with the user guide and manual data entry, variant 2 . 25 The User Guide Settings 8 9-15 Copying from a second recorder, CD-i player Operation with a Satellite Receiver Operation with a PAY-TV Decoder Special Functions 26 27-30 31 32-35 Tuning the TV set to the recorder 9 Tuning . [. . . ] 7 PROGRAM DAY START STOP CK CLEAR SET/CHE TIMER ON/OFF SP/LP SV/V+ 1 2 5 8 0 3 6 9 AV 1 Operation Select programme position, step by step using the DC / ®; directly using the numbered buttons 1 . . . For two-digit programme positions, press the second numbered button directly after the first. 2 4 3 ND 4 7 VPT 1 + OK + 1 - 6 5 EX IN D 2 Start recording by pressing the K / K button for a long period. Select recording pause using the W /V button. Resume recording with the K / K button. TR A EX M ARK CK IN G 3 INDEX ER A SE 4 5 End recording using the H /u button. To do this press the X Y/} { buttons while in stop function. Terminate fast winding with the H/u button. Instant recording (record what you see) If the recorder is connected to a TV set with Megalogic functions then the TV station which is currently on the TV screen can be recorded with the K/K button. The programme position on the recorder must not be selected. The TV set can be switched off during recording or another programme position can be selected. Immediate recording can also be done with television sets without Megalogic functions. Recorder and television set must be connected with a Euro AV cable. 6 7 Remove the cassette by pressing the N/w button. Switch off the recorder using the A/ z button. Recording I 19 Entering a stop time ! Recording continues to the end of the tape. The recorder switches automatically to rewind, rewinds the tape to the beginning and switches to standby. For this, there are two options: Entering to the exact minute; Entering in 30-minute steps. Use the buttons on the remote control for this function. Assembling recordings with clean joints (assembly editing) 1 During playback, locate the tape position at which you wish to join the recording. Switch the recorder to recording pause using the K /K button. Enter the desired programme as a one- or two-digit number using the numbered buttons 1 . . . Start the » new « recording with the K /K button. ­ During playback you will see seamless transitions without flaws. This is called assembly editing. 2 3 4 Recording 20 1 2 Entering stop time to the exact minute Press the K button during recording. Enter the desired stop time as a four-digit number using the numbered buttons 1 . . . 0 and confirm using the G button. 1 2 Entering stop time in 30-minute steps Press the K button during recording. [. . . ] For VPS/PDC-programmed recordings, VPS/PDC time was entered incorrectly. The ON/OFF button was not pressed after an interruption of the record standby mode ( TIMER flashes). Timer recording was not carried out. ¢ Poor picture quality during playback. The TV set is not correctly tuned to the transmitting channel of the video recorder. The video heads are dirty. Correctly tune the TV set to the transmitting channel of the recorder. Press the TRACKING button during playback and keep it pressed for a few seconds. The video heads are cleaned, the playback picture cannot be seen during this time. ¢ The video heads are worn. [. . . ]