User manual GRUNDIG M 100-A service manual

[. . . ] ­ Each tray can accommodate only one disc. ­ "E-07" appears about 8 seconds if the disc is placed upside down. First check that the magazine with the discs inside has its top side facing up and that it is pointed in the right direction for installation. Push it in until it clicks into place, indicating that it is now locked. [. . . ] if the cable is disconnected , the computer memory may be lost. Under these conditions, use extra caution to avoid causing a short circuit during installation. Do not install the unit in the following locations: ­ Locations exposed to direct sunlight. ⭠Where hot air is discharged from the car heater. ­ When proper installation is not possible and where a great deal of vibration is generated. ­ Be sure to use the supplied brackets and screws. ­ When installing the unit, do not use any screws that are part of the brake or steering system. This unit cannot be installed in any way except that which is authorized (on its side, on its end, at a 45° angle or suspended). Installing it with its side facing down or upside down can cause malfunctioning. Caution: After removing the transport lock screws, place the supplied seals over the screw holes. These seals are used to keep dust, which could cause a malfunction, out of the unit. ⭠Attach brackets (L) and (R) using the hexagonal bolts (M5 x 8). ­ Attach brackets (L) and (R) to their respective brackets (B) using the hexagonal bolts (M6 x 20) and the hexagonal nuts (M6). 2 ­ Pull back the carpet and determine where to attach the unit. ­ Stick the supplied double-sided tape to the bottom of the brackets (B) and peel off the paper backing. ­ Affix the unit to the floor by pressing in place. 4 ­ Using a knife, cut "X"s in the carpet directly above the brackets (B) bolts. ­ Return the carpet to its original position allowing the bolts to stick through. 3 ­ Remove the hexagonal nuts and take off the changer. 5 ­ Once more, use the hexagonal nuts to attach the changer on top of the carpet. 1 ­ Set the built-in anti-vibration boards on both the left and the right sides to the 45° installation position "45°". ⭠Attach brackets (L) and (R) using the hexagonal bolts (M5 x 8). [. . . ] Wipe in a straight motion from the inside to the outside of the disc. Small dust particles or light stains will have absolutely no effect on reproduction quality. Never use such chemicals as record sprays, antistatic sprays or fluid, benzine or thinner to clean compact discs. Problems which arise because of a bad manipulation of the set or incorrect connections are often wrongly considered to be a malfunction of the set. [. . . ]