User manual GRUNDIG MS 4020

[. . . ] When the appliance is connected to the wall socket, on no account should it come into contact with water or any other liquid. After using the appliance, pull out the power adapter from the wall socket. Never use the appliance if it, the cutting foils or the blade blocks are visibly damaged. Do not completely immerse the appliance in water. The appliance may only come into contact with water once it is disconnected from the power adapter and the power adapter is no longer in the socket. 1 ENGLISH 3 OVERVIEW _________________________ _ Dear Customer, Congratulations on the purchase of your MS 4020 men's shaver. [. . . ] Replace any damaged parts before shaving. 2 Plug the power adapter K into the power adapter socket C and the power adapter plug into the wall socket. 3 Push the On/Off switch B to switch on the appliance. 4 Shave with slow, gentle movements against the direction of beard growth. Hold the appliance at a 90° angle to your skin. Caution Always pull the skin taut when shaving difficult areas such as your lower jaw. Always cut against the natural direction of beard growth. In the case of thick or copious beard growth which cannot be removed by just one shave, do one quick shave and then a more thorough second one. Do not press too hard as you may damage the foils. 5 After use, switch off the appliance with the On/Off switch B , disconnect the plug from the wall socket and put the plastic cap back on. 1 6 ENGLISH INFORMATION ____________________ _ Cleaning and care General information The appliance must be cleaned regularly so that you can continue to enjoy its top performance and optimum results. Clean the housing with a soft cloth and a mild detergent. 4 To remove all hair, hold the blade blocks F under running water and switch on the appliance. Cleaning with water 1 Push the On/Off switch B to switch off the appliance. 2 To remove the foil frame, push one of the side lock buttons E with your thumb to lift up this side of the foil frame. Then push the second button at the other side and lift up the foil frame. 3 Rinse out the foil frame under running water. Gently shake out the remaining moisture and then dry off the appliance with a clean cloth. 6 Replace the foil frame A and let it latch into place. Cleaning with the brush 1 Push the On/Off switch B to switch off the appliance. Caution The appliance must be disconnected from the power adapter. To do so, push the side lock buttons E . 1 ENGLISH 7 INFORMATION ____________________ _ 3 Remove the blade blocks F for cleaning by pulling them upwards off the oscillator H . 4 Carefully brush hair clippings out of the blade blocks, the foils and the housing. Caution The foils can be irreparably damaged during cleaning. 5 Put all parts on again after cleaning. Caution To ensure smooth operation, the foil frame must be properly seated in the housing. [. . . ] Make sure the appliance is kept out of the reach of children. Power supply: 100 - 240 V~, 50/60 Hz Washable (IPX4) Suitable for cleaning under an open water tab. WARNING: Detach the hand-held part from the supply cord before cleaning it in water. Design and specifications subject to change without notice. Technical data This product conforms to European directives 2004/108/EC, 2006/95/EC and 2009/125/EC. Environmental note This product is manufactured from high-quality parts and materiais which can be reused and recycled. [. . . ]