User manual GRUNDIG MT 6540 APARADOR BARBA 4IN1

[. . . ] Mains adapter. C D E F G H ENGLISH 17 POWER SUPPLY ___________________________________ Operation with rechargeable batteries When using the built-in rechargeable nickel metal hydride batteries, use the mains adapter M supplied as a charger. 1 Plug the mains adapter into the H socket, and plug the mains adapter into the mains socket. Notes 7 Completely charge up the batteries (16 hours) before you first use them or if you have not used them for a long time. 7 7 When fully charged, the appliance works for around 45 minutes. It is not advisable to charge the batteries after every use, especially if you do not use the appliance for the full 45 minutes. [. . . ] 2 Carefully plug the comb I onto the cutting head until it catches. You must be able to see the numbers on the comb on the back of the appliance. Please note that the telescopic comb can only be used with the wide side of the cutting head B . 3 Set the required beard trimming length using the grade adjuster J on the telescopic comb. The numbers 2, 4, 6, 8 and 10 are the length in millimetres. 4 Then switch on the appliance using the switch A and start trimming your beard. Move the appliance in the direction your beard grows and make sure the comb is always in contact with your skin. To not make excessively quick movements. 20 ENGLISH OPERATION ________________________________________ Function 2 Beard trimming . . . . . . using the narrow side of the cutting head C without the telescopic plug-in comb. Note that you cannot use the telescopic plug-in comb I with this method. The narrow side of the cutting head is used for precise trimming of small areas. 1 Make sure the appliance is switched off. 2 Take off the comb I : Release the comb I by gently pressing with two fingers on the release buttons on the side, and lift it off. 3 Taking off the cutting head or accessories: Grip the cutting head or the accessory from the side and turn it to the left until it is released. 1 2 4 Putting on the cutting head or accessory: Turn the cutting head or accessory by 180° to the new cutting position. Push the cutting head or the accessory into the housing and lock it by slightly moving it to the right and then gently pressing it down. 7 Note Danger of injury!When adjusting the cutting head, make sure you do not accidentally switch on the appliance with the switch A. ENGLISH 21 OPERATION ________________________________________ Function 3 Beard trimming . . . . . . 1 The shaver K is for complete beard removal on selected, small areas. Note that you must first trim long beard hair with one of the two blades B or C . 2 Make sure the appliance is switched off. 3 Take off the head you were previously using as described under function 2. 4 Put on the shaver K as described under function 2. 5 Then switch on the appliance using the switch A and start shaving. Function 4 Nostril hair removal . . . . . . [. . . ] 4 Before using the appliance again, dry all parts completely using a towel. Notes 7 Remove any clippings after each use. Note 7 Normally you do not need to oil the cutting head, because it is made of two different materials (ceramic and steel). If you want to maintain the original condition of the cutting head for as long as possible, it is worth oiling it at regular intervals (with the oil provided). Storage If you do not want to use the appliance for a long period of time, please store it carefully. [. . . ]