User manual GRUNDIG PLANIXX CDP 4104 AS 40 PLL

[. . . ] PORTABLE CD-PLAYER WITH DIGITAL RADIO CDP 4104 AS 40 PLL Planixx ENGLISH SAFETY___________________________________________________ Safety To ensure that this device provides you with long-term satisfaction and enjoyment, please observe the following instructions: This device is designed for the playback of audio signals. You must make sure that the device is protected from moisture such as rain or water splashes. When deciding where to place the device, please note that furniture surfaces are covered by various types of varnish and plastic, most of which contain chemical additives. These additives can corrode the device supports, leaving residues on the furniture surfaces which can be difficult or impossible to remove. [. . . ] Insert two batteries, observing the polarity marked on the bottom of the battery compartment. Plug the mains adapter into the »DC IN 6V« socket on the device and plug the mains adapter onto the mains socket. ­ The »CHARGE« indicator lamp lights up. Note: When buying NiCd batteries, always make sure that approximately 3 mm of the metal end at the negative pole is visible (see illustration). If necessary, use a knife to remove the insulation. Completely charge up the batteries before you first use them or if you have not used them for a long time. The charging time is approximately 12-14 hours. Using the device while the batteries are charging increases the charging time. 3 mm min 21 ENGLISH PREPARATION ______________________________________ Connecting the earphones and the remote control 1 2 Connect the earphones to the » PHONES« socket on the remote control (ø 3. 5 mm). Connect the remote control to the » PHONES 0« socket on the CD player. Note: You can also connect the earphones directly to the device. If you do this, however, the remote control will not work. Excessive volume can be dangerous to yourself and other road users. Listen at a volume which still allows you to hear outside noises such as horns, emergency vehicles and police cars. This portable CD player with headphones meets the requirements set out in Articles LL44. 5 and 6 of the German safety regulations. The output of the device guarantees the best possible sound at medium volume. Prolonged listening at loud volumes can damage your hearing. CHAR GE OP EN VOLUME LINE OUT D AS 22 8 7 8 PROGR. M O DE Adjusting the volume 1 Adjust the volume with » VOLUME on the remote control. g« on the device or »gVOL« Ultra Bass System 1 Press » OFF ULTRA BASS SYSTEM ON« on the device to switch the Ultra Bass system on and off. BASIC FUNCTIONS CD________________________ Selecting the CD input source 1 Press »CD RADIO« on the device to switch to CD mode Inserting a CD The device is suitable for music CDs displaying the logo shown here or for CD-Rs with audio data. As well as standard 12 cm CDs, it can also play 8 cm CDs without an adapter. 1 2 3 Push the » OPEN compartment. 4« slider to the right and open the CD Insert the CD with the label facing upwards and gently push the centre of the CD to latch it into place. Close the CD compartment. Removing the CD Note: Press » STOP I« before you open the CD compartment during playback. 1 2 3 Push the » OPEN compartment. Remove the CD Close the CD compartment. 4« slider to the right and open the CD Digital anti-shock system (DAS) The anti-shock system reads the data on the CD 40 seconds in advance. This prevents interruptions to playback due to shocks and vibrations. 0 1 0 0 : 00 p 0 1 0 0 : 08 o 1 Press »D. A. S« to switch on the anti-shock system. [. . . ] You will find a symbol similar to the one shown here on the bottom of the device. CLASS 1 LASER PRODUCT means that the laser is designed in such a way as to ensure that the maximum permissible emission value cannot be exceeded under any circumstances. If operating devices or methods other than those specified here are employed, it may lead to dangerous exposure to emissions. Invisible laser radiation is emitted if the CD compartment is opened and the safety locking mechanism is shorted. [. . . ]