User manual GRUNDIG RRCD 1300

[. . . ] RADIO CASSETTE RECORDER WITH CD RRCD 1300 RRCD 1310 ENGLISH OVERVIEW ______________________________________________________ Controls General information CD TAPE/OFF RADIO + VOLUME ­ UBS 0 Switches between the CD, TAPE and RADIO input sources. Switches the Ultra Bass System on and off. Headphone jack for connecting a headphone set with a jack plug (ø 3. 5 mm) on the left side of the device. This automatically switches off the loudspeakers. [. . . ] No warranty claims are accepted for damage resulting from improper handling. Thunderstorms are a danger to all electrical devices. Even if the device is switched off, it can be damaged by a lightning strike to the mains. Always remove the mains plug during an electrical storm. Do not use any cleaning agent, as this may damage the casing. Clean the device with a clean, moist leather cloth. Please note when deciding where to put the device that furniture surfaces are covered by various types of lacquer and plastic, most of which contain chemical additives. These may cause corrosion to the feet of the device, thus resulting in stains on the surface of the furniture which can be difficult or impossible to remove. General information on laser devices You will find a symbol similar to the one shown here on the bottom of the device. CLASS 1 LASER PRODUCT CLASS 1 LASER PRODUCT means that the laser is designed in such a way as to ensure that the maximum permissible emission value cannot be exceeded under any circumstances. If operating devices or methods other than those specified here are employed, it may lead to dangerous exposure to emissions. Invisible laser radiation is emitted if the CD compartment is opened and the safety locking mechanism is shorted. Do not expose yourself to this radiation. 25 ENGLISH GENERAL FUNCTIONS __________________________________ Switching on and off 1 2 Switch on the device with the required input source by moving the switch to the »CD TAPE/OFF RADIO« position. Move the »CD TAPE/OFF RADIO« switch to the »TAPE/OFF« position to switch off the device. Selecting the input source 1 Select the input source (CD, TAPE or RADIO) using »CD TAPE/OFF RADIO«. Adjusting the volume 1 Adjust the volume with »+ VOLUME ­«. Switching the Ultra Bass System on and off This function boosts the bass frequencies. 1 Switch the Ultra Bass System on and off with »UBS«. Listening with headphones 1 Connect the headphones to the headphones socket »0« (ø 3. 5 mm) on the left of the device. ­ This switches off the loudspeakers. RADIO MODE _________________________________________________ Antennas 1 For FM stations (VHF) extend the telescopic antenna »ANTENNA«. Note: If the FM signal is too strong, it is advisable to push in the telescopic antenna. 2 The radio has a built-in rod antenna for MW reception. Turn the device around to direct the antenna. Selecting the radio input source 1 Move the »CD TAPE/OFF RADIO« switch to the »RADIO« position. Selecting radio stations (RRCD 1300) 1 2 Select the frequency band (FM or MW) with »FM MW« (on the right side of the device). Select the radio station using »TUNING« (on the right side of the device). When burning CD-R and CD-RWs with audio files, various problems may arise which could lead to interference in playback. This can be caused by faulty software or hardware settings or by the CD being used. Should such problems arise, contact the customer services of your CD burner or software manufacturer or look for relevant information, for example on the Internet. When you are making audio CDs, observe all legal guidelines and ensure that the copyright of third parties is not infringed. Always keep the CD compartment closed to prevent dust from collecting on the laser optics. [. . . ] ­ The device automatically stops recording at the end of the tape. · CD synchro recording 1 2 3 Put in a cassette with the protection tabs intact and press » position on the tape. « or » « to find the Move the »CD TAPE/OFF RADIO« switch to the »CD« position. Press » « to start recording. ­ The » « button is automatically engaged. [. . . ]