User manual GRUNDIG VCC 7650 PORSZÍVÓ 2400W

[. . . ] Do not roll the appliance over the power cord. Do not close any doors above the power cord. Do not pull the power cord over sharp edges and do not crush it. If you move the appliance into another room, always disconnect the plug at the wall socket and carry the appliance by the handle. [. . . ] 1 Push the brush or Fabric Master directly onto the guide handle for better control. 2 Push the brush or Fabric Master onto the extendable telescopic vacuum tube D for greater reach. 3 Alter the switch F on the combi-floor brush E depending on the carpet thickness. F E Brushes The vacuum cleaner is supplied with three different brushes and a cleaning roller (Fabric Master): ­ Laminate brush: for cleaning wooden floors such as laminate, parquet, etc. ­ Turbo floor brush: ideal for removing stubborn dirt or animal hairs and for cleaning upholstered furniture. ­ Combi floor brush: Carpet brush with height adjustment depending on the carpet thickness. ­ Fabric Master: Cleaning roller for cleaning textiles and fabrics, e. g. curtains (does not suck in the material). Use one of the three brushes above or the Fabric Master depending on the requirements. 18 ENGLISH INDIVIDUAL PARTS _____________________________________________ Narrow crevice tool Use the narrow crevice tool H to clean places difficult to reach, e. g. 1 Push the narrow crevice tool directly onto the guide handle for improved control. 2 Push the narrow crevice tool onto telescopic vacuum tube D for greater reach. Small brush Use the small brush G for cleaning e. g. 1 Push the brush directly onto the guide handle for improved control. 2 Push the small brush onto telescopic vacuum tube D for greater reach. H G Storing the accessories 1 Fix the narrow vacuum tube and the small brush in the holder on the guide handle B . B ENGLISH 19 USE _________________________________________________________________________ Switching on and off Check whether the mains voltage given on the rating plate (on the underside of the appliance) matches the local mains voltage. 1 Pull out the required length of power cord. Important 7 A yellow mark appears at the end of the cable. The maximum cable length is indicated by a red mark. Never try to pull out the power cord beyond the red mark. 2 Plug the power cord plug into the wall socket. 3 Switch on the appliance by pressing pushbutton I . 4 Use the slide switch N to set the required suction power. Preparation IYour appliance is supplied with a dust bag already fitted. Once you have assembled the individual parts the appliance is ready to use. 1 Push the plug-in contact of the flexible hose A in the socket provided on the dust container J until it latches into place. Note 7 To remove the flexible hose A , press the side release buttons on the plug-in contact and then pull out the hose. A N J I 5 After use, press pushbutton I to switch off the appliance and remove the power cord plug from the wall socket. [. . . ] 3 Remove any blockages, if necessary change the dust bag or clean the filter. 4 Leave the motor to cool for approx 30 to 40 minutes. 5 Then reconnect the appliance and switch on. 6 If the appliance cannot be switched on, wait for 20 minutes and then try again. [. . . ]