User manual GRUNDIG VCH 7630 HANDHELD VACUUM CLEANER 14,

[. . . ] Do not use the appliance if the air inlet and ventilation slits are blocked. Keep the air inlet and ventilation slits free at all times of dust, hairs and other elements which could block or prevent the air flow. 7 7 If using with the motorised brush, ensure you constantly move the brush backwards and forwards and do not allow it to rotate too long on a stain. The motorised brush may only be cleaned if it is not connected to the appliance. Never start up the appliance if it shows signs of visible damage. [. . . ] 1 Ensure the place you have chosen to install the charger is free of concealed electric cables, water or gas pipes. 2 Choose an installation location near a wall socket (230 V, 50 Hz) for connecting the mains adapter. Important 7 Do not install the charging station anywhere where it is exposed to direct sunlight or near a heater/radiator. 3 Choose a suitable drill bit for the screws and wall plugs supplied. 4 Drill two holes approx 30 cm above the floor, push in a wall plug and screw in the screws, then hang up the charging station. Use the narrow vacuum tube M to clean places difficult to reach, e. g. Use the upholstery brush N to clean small areas of upholstery. 2 Firmly push the narrow vacuum tube or the upholstery brush into the appliance's vacuum intake C . J 16 ENGLISH USE ________________________________________________________________________ Switching on and off If run with the installed rechargeable nickel cadmium batteries, use the charging station with the mains adapter as a charger. 1 Remove the appliance from the charging station J . 2 Depending on the requirements, insert one of the accessories into the appliance's vacuum intake C . 3 Switch on the appliance by pushing forward switch F . 4 Switch off the appliance by pushing back switch F . 6 Insert the appliance in the charging station J so that it precisely fits. Charging If run with the installed rechargeable nickel cadmium batteries, use the charging station with the mains adapter as a charger. 2 Insert the appliance in the charging station J so that it precisely fits. ­ The charging contacts of the appliance and the charging station touch each other. 3 Plug the mains adapter into the wall socket. ­ The charging process begins, the charging indicator E lights up red. ­ The charging indicator remains lit until the appliance is removed from the charging station or the mains adapter plug is disconnected. ­ If charging has finished the red charging indicator goes out. Note 7 Fully charge the batteries before using for the first time or if the batteries have not been used for a long time. (20 hours). 7 Empty dust container and clean 1 Hold the appliance vertically with the vacuum intake C facing downward. 2 Press pushbutton D and remove the dust container from underneath. 3 Remove the holder and filter B from the dust container. [. . . ] 1 Undo the screw on the cover of the compartment (underside of the appliance). 4 Remove the rechargeable batteries and undo the cable connections. 5 Connect the cable connections to the new batteries, then insert the batteries and the safety clasp. Environmental information 7 Never throw the rechargeable batteries in the domestic waste. [. . . ]