User manual GRUNDIG VCH 8830 HANDHELD VACUUM CLEANER

[. . . ] The motorised brush may only be cleaned if it is not connected to the appliance. Never start up the appliance if it shows signs of visible damage. This also applies to an accidentally wettened appliance. In such cases, contact your local specialist store. [. . . ] Never use the motorised brush on long hair/deep pile carpets. 2 Firmly push the motorised brush into the appliance's vacuum intake C . Note 7 When you install the motorised brush ensure the contacts of the brush touch the contacts in the appliance's vacuum intake. Important 7 Do not touch the motorised brush during use. Risk of injuries. 7 Use the universal vacuum brush K together with the three extension tubes O to clean small floor areas or curtains. 2 Firmly push an extension tube into the appliance's vacuum intake C . 3 Depending on your requirements, insert one or two extension tubes into the first extension tube. 4 Push the universal vacuum brush K onto the bottom extension tube. O If using with the motorised brush, ensure you constantly move the brush backwards and forwards and do not allow it to rotate too long on a stain. ENGLISH 13 INDIVIDUAL PARTS Narrow vacuum tube and upholstery brush ____________________________________________ Charging station for mounting on a wall Fix the charging station J to a wall. 1 Ensure the place you have chosen to install the charger is free of concealed electric cables, water or gas pipes. 2 Choose an installation location near a wall socket (230 V, 50 Hz) for connecting the mains adapter. Important 7 Do not install the charging station anywhere where it is exposed to direct sunlight or near a heater/radiator. 3 Choose a suitable drill bit for the screws and wall plugs supplied. 4 Drill two holes approx 30 cm above the floor, push in a wall plug and screw in the screws, then hang up the charging station. Use the narrow vacuum tube M to clean places difficult to reach, e. g. Use the upholstery brush N to clean small areas of upholstery. 2 Firmly push the narrow vacuum tube or the upholstery brush into the appliance's vacuum intake C . J 14 ENGLISH USE ________________________________________________________________________ If run with the installed rechargeable nickel metal hydride batteries, use the charging station with the mains adapter as a charger. Switching on and off 1 Remove the appliance from the charging station J . 2 Depending on the requirements, insert one of the accessories into the appliance's vacuum intake C . 3 Switch on the appliance by pushing forward switch F . 4 Switch off the appliance by pushing back switch F . 5 Remove the accessory used. Charging If run with the installed rechargeable nickel metal hydride batteries, use the charging station with the mains adapter as a charger. 2 Insert the appliance in the charging station J so that it precisely fits. ­ The charging contacts of the appliance and the charging station touch each other. 3 Plug the mains adapter into the wall socket. [. . . ] The filter and the inside of the dust container can be washed with hot soapy water. Do not wash the filter in the washing machine. The filter and dust container must be completely dry before they are used again. Before using, ensure the motorised brush is free of hairs and fibres. Replace the rechargeable batteries If damaged, the appliance may only be opened by an authorised technician. [. . . ]