User manual GRUNDIG VCS 2660 ELECTRIC SWEEPER

[. . . ] FLOOR SWEEPER VCS 2660 de en ________________________________________________________________________________ 2 ________________________________________________________________________________ E B A D F G C H 3 ________________________________________________________________________________ 4 ________________________________________________________________________________ DEUTSCH ENGLISH 6 - 10 11 - 15 5 SAFETY __________________________________________________________________ Please note the following when starting up the appliance: 7 This appliance is intended for domestic use only. All guarantee claims expire if it is used for industrial or commercial purposesl. Do not use the appliance in a wet environment. [. . . ] All rights to claim under the guarantee are invalidated for damage caused by improper interventions. 7 7 7 7 7 7 7 7 7 7 ENGLISH 11 PREPARATION _____________________________________________________ Controls und component parts Fold out page 2 to clearly see the diagram at all times. A Base unit. B Connection socket for inserting the handle Assembly 1 Insert the silver end of the bottom handle pole F in the connection socket B of the base unit A . pole. C Charge indicator. Lights up while the applian- ce is charging. D Pushbutton for switching on and off. H Dust container. Accessories I Mains adapter for charging the integrated rechargeable battery. 2 Push the bottom end of the upper handle pole G over the black end of the lower handle pole and push down the pole until it sits tight. Special features ­ The appliance is suitable for cleaning all floors such as tiles, carpet, parquet, etc. Do not use the appliance to clean deep pile carpets. ­ 900 ml dust collection container. 12 ENGLISH PREPARATION _____________________________________________________ 3 Insert the grip handle E in the upper end of the upper handle pole and push it down until it sits tight. 1 Stand the appliance on a hard surface and ensure adequate ventilation in its surroundings. 2 Plug the mains adapter plug I into the wall socket. 3 Plug the mains adapter cable plug into the socket on the rear of the appliance (see Figure). ­ The appliance is now ready for charging. Charge rechargeable battery If run with the installed rechargeable nickel cadmium battery, use the supplied mains adapter as a charger. Switch off the appliance before charging. Check whether the mains voltage given on the rating plate of the mains adapter supplied matches the local mains voltage. The appliance is not disconnected from the power supply until the mains adapter is disconnected. Important: Use the supplied mains adapter only for charging. Before using for the first time you must charge the battery for 14 hours to ensure it reaches its maximum life. After the initial use charging takes 8 hours. Notes: If you do not use the appliance for a long time, do not leave it to charge at the mains adapter. Unplug the mains adapter at the wall socket and remove the mains adapter cable plug from the appliance. [. . . ] This is indicated by the following symbol on the product, in the instructions for use or on the packaging. Technical specifications This product fulfils the European Directives 89/336/EEC and 73/23/ EEC. Order number GML 4900 Power supply 230 V~ 50 Hz at the wall socket DC 9 V at the mains adapter Rechargeable batteries: 6 V nickel cadmium Protection class III Weight (WEEE) Please contact your local authority to find out where your local collection points are. Reusing and recycling old appliances is an important contribution to protecting our environment. 1800 g Ni-Cd Subject to technical and visual changes! ENGLISH 15 Grundig Multimedia B. V. Atrium, Strawinskylaan 3105 · NL-1077 ZX Amsterdam · http://www. grundig. com [. . . ]