User manual GRUNDIG WT-AV 1

[. . . ] Should they be knocked over, fluid may spill on the electrical components, thus presenting a safety risk. Make sure no foreign bodies get inside the device, as this may cause a short circuit. Ensure that the device is protected from moisture such as rain or water splashes. Thunderstorms are a danger to all electrical devices. [. . . ] Video signal output for the video signal of the device being used. Channel switch, for setting the transmission channel. Four different settings can be selected. This allows up to four systems to be independently operated. The switch for the selected channel must be set to » DIP ON«. ON/OFF switch. 4 5 6 7 8 DC 9V@ G 16 CONNECTION ______________________________________ Connecting the WT-AV 1 Transmitter CH 8 Xenaro ANT IR R · AUDIO · L IN VIDEO IN I 2 DIP 3 ON 4 3 CH I 2 3 4 DC 9V DIP ON 4 5 2 6 7 1 Note: Use the cinch/EURO-AV cable labelled "for Transmitter". 1 Insert the EURO-AV plug of the cable in the EURO-AV socket of the signal source (e. g. 2 Insert the cinch plug of the cable in the cinch socket of the transmitter. ­ Yellow ­ video signal, red ­ audio signal right, white ­ audio signal left. 3 On the channel switch » CH« select a transmission channel by sliding a switch into the » DIP ON« position. The other switches must remain in the upper position. 4 Insert the jack plug of the infra-red module into the » IR« socket. I 2 DIP 3 ON 4 5 Remove the protective film of the adhesive tape from the infra-red receiver and attach the infra-red receiver to the infra-red sensor of the signal source (e. g. Note: For the correct position of the infra-red sensor of the signal source, see the operating instructions for the signal source you are using. When attaching the infra-red receiver, make sure that the infra-red sensor of the signal source is not completely covered. This might make direct operation of the device via remote control impossible. The second infra-red receiver can be used for another device. 6 Insert the mains adapter plug into the » DC 9V@« socket. 7 Insert the mains adapter in the socket. 8 Position the antenna upright. 17 ENGLISH CONNECTION ________________________________________ Connecting the WT-AV 1 Receiver to the TV CH 6 I 2 DIP 3 ON 4 3 ANT R · AUDIO · L OUT VIDEO OUT I CH 2 3 4 DC 9V DIP ON 2 4 5 EURO-AV 1 3 2 1 4 7 5 8 0 6 9 Note: Use the cinch/EURO-AV cable labelled "for Receiver". 1 Insert the EURO-AV plug of the cable in the EURO-AV socket on the television set. 2 Insert the cinch plug of the cable in the cinch socket of the receiver. ­ Yellow ­ video signal, red ­ audio signal right, white ­ audio signal left. [. . . ] a babyphone) is interfering with the transmission. Check the connection and position of the infra-red module. Switch this device off. 20 TECHNICAL DATA ________________________________ 0682 The WT AV1 is noise-suppressed according to the applicable EU directives. These products fulfil the European directives 89/336/EEC and 73/23/EEC. [. . . ]