User manual GTO PRO-SW 1500 DUAL

[. . . ] Our corporate headquarters and state of the art manufacturing facility is located in Tallahassee, Florida. One of our highest priorities is to provide outstanding technical service to our customers. Therefore, if you have any questions or require any technical assistance, please call our toll free line 800-543-1236 or 850-575-4144 and ask to speak to one of our technicians. Prior to installing your 1500 Dual Gate Operator Connection Kit, please read this manual thoroughly. [. . . ] ON: Continuous output at `AUX OUT' terminal when gate is moving. 15 1 2 Disconnect Receiver Wires PULL-PUSH CHARGING MODE1 POWER MODE2 LOCK/BEACON 18VAC SOLAR PANEL LINK GRN EXIT SAFETY EDGE AUX OUT COMMON CYCLE RCVR 6 Setting the CLOSE LIMIT (Pull to open installation only): FF 1. DIP switch #1 should be in the OFF position. Turn the ON/OFF switch to the ON position on the master arm. Turn the ON/OFF switch to the ON position on the slave arm. Wait 15-20 seconds for the receiver to `warm-up'. Press the remote (assuming that the remote has already been `learned'). The SLAVE arm or both arms (depending on your sequence setting) should be closing. Press the remote again to stop the gate at the desire closed position. Note: whichever gate reached its desired closed position first that will be the first one to be programmed. If the SLAVE arm is stopped at the desired closed position, press the `SET LIMIT' on the SLAVE arm for 5 seconds. If the MASTER arm is stopped at the desired closed position, press the `SET LIMIT' on the MASTER arm for 5 seconds. Press the remote again and allow both gates to return to the fully opened positions. Repeat step 5 for the side that has not been programmed in the previous step. 4 RED BLK ON/O FF STATUS MIN MAX STALL FORCE OFF 120 CLOSE TIME SET LIMIT LEARN REMOTE ON PULL-PUSH MODE1 MODE2 LOCK/BEACON RF 3 4 ON 1 2 3 4 7 Setting the open limit (Push to open installation only): 1. DIP switch #1 should be in the ON position. Turn the ON/OFF switch to the ON position on the MASTER arm. Turn the ON/OFF switch to the ON position on the SLAVE arm. Wait 15-20 seconds for the receiver to `warm-up'. Press the remote (assuming that the remote has already been `learned'). The SLAVE arm or both arms (depending on your sequence setting) should be opening. Press the remote again to stop the gate at the desire opened position. Note: whichever gate reached its desired opened position first that will be the first one to be programmed. If the SLAVE arm is stopped at the desired opened position, press the `SET LIMIT' on the SLAVE arm for 5 seconds. If the MASTER arm is stopped at the desired opened position, press the `SET LIMIT' on the MASTER arm for 5 seconds. [. . . ] · 3121 Hartsfield Road · Tallahassee, Florida 32303 Telephone (850) 575-0176 · Fax (850) 575-8912 · website www. gtoinc. com The contents of all material available on this installation manual are copyrighted by GTO, Inc. ("GTO"), unless otherwise indicated. All rights are reserved by GTO, and content may not be reproduced, downloaded, disseminated, published, or transferred in any form or by any means, except with the prior, written permission of GTO. Any reprinting of GTO publications is by permission only. [. . . ]