User manual GTO PRO-SW 50006000

[. . . ] INSTALLATION INSTRUCTIONS FOR GTO/PRO SW-5000 and GTO/PRO SW-6000 AC Powered Swing Gate Operators LI US STED WARNING! · READ ALL INSTRUCTIONS COMPLETELY before attempting installation and use; failure to do so may result in serious injury or death!· This unit must only be installed by an experienced technician!Contact with gate operator circuitry can cause serious injury or death!Operator power must be disconnected before servicing! [. . . ] Attach the gate bracket to the end of the adjusting bracket with (1) bolt and (1) Nyloc nut. 4. 1/2" 5. Swing the gate to its fully closed position. Pivot the gate arm assembly toward the gate until it is fully extended. Make sure that the gate arm assembly is level. Using the height of the level gate arm assembly as a reference, clamp a support bar (not provided) for the gate bracket to the gate. Attach the gate bracket to the support bar with (2) 1/2" bolts, lock washers, and nuts (not provided). Swing the gate through its full operating arc to verify that the gate arm retracts and extends without binding. Opening and closing the gate in this manner will also test the clearance between the gate and the operator. Permanently bolt or weld the support bar to the gate once its correct position has been determined. Connecting Power to the Operator Have a licensed electrician run 115 Vac wiring into a Field Wiring Connection Compartment (ON/OFF) box. The 115 Vac line will power the gate operator system. The circuit must be protected with a 15 A main disconnect breaker (not provided). NOTE: Power and wiring connections MUST be installed by a licensed electrician in accordance with NEC (National Electric Code) and local codes. NEVER run low voltage (e. g. , accessory or receiver) wires in conduit containing 115 Vac wiring. After the gate operator is connected to the 115 Vac power supply, the limit switches can be set. See ADJUSTING THE LIMIT SWITCHES on the next page. 14 ADJUSTING THE LIMIT SWITCHES The limit switches determine how far the gate travels to open and close. The closer the limit nut is to the limit switch, the less distance the gate will travel to open or close. Adjust the limit switches by moving the limit nuts. MAKE SURE THE OPERATOR POWER IS OFF BEFORE ATTEMPTING TO ADJUST THE LIMIT SWITCHES. Lift and release the limit switch plate to unlock the limit nuts (see illustration at right). Using a fingertip, roll the limit nuts along the travel shaft until the correct open and closed gate positions are determined. If the operator is mounted to the LEFT of the gate (see illustration below): the left limit switch adjusts the open position. The right limit switch adjusts the closed position. If the operator is mounted to the RIGHT of the gate (see illustration below): the right limit switch adjusts the open position. [. . . ] Products received at the factory without an RGA number will not be accepted. Replacement or repaired parts are covered by this warranty for the remainder of the warranty period or six (6) months, whichever is greater. GTO will pay shipping charges (equivalent to United Parcel Service ground rate) for return to owner of items repaired under warranty. The manufacturer will not be responsible for any charges or damages incurred in the removal of the defective parts for repair, or for the reinstallation of those parts after repair. [. . . ]