User manual H2O AUDIO IDIVE300

[. . . ] www. H2OAudio. com Deep Dive Waterproof Case & Speakers Depth Rating 300ft/90m For updated manuals please visit our web site www. h2oaudio. com iDV1-75 20080819 Mask Clip O-ring Speaker Lanyard Hole iPod Control Buttons Insert Holes & Height Adjuster Holes ® LED lights Battery Cover Cam Knob Depth Rating 300ft / 90m Connector Cable Cam Knob Lock 1 2 Quickstart: I. Read "Getting Familiar with the iDive 300" II. Install iPod specific inserts and height adjusters (see page 10 for fit chart) V. Press and hold the power button on the iDive300 case (Green LED should light on back of case) Instructions: I. [. . . ] When the Blue LED is illuminated there is some limited function of the iPod controls. In case of a Blue LED Restart the iDive300 by turning the power off then on. Disconnect the connector cable from the iPod. Reconnect the connector cable to the iPod. Turn on the iDive300. Mode Power 12 Menu Previous/Fast-forward Up Volume Play/Pause Down Controls Next/Fast-forward Select 11 In case of a Steady Red LED 1. Ensure you are using a supported iPod model. Disconnect & reconnect the connector cable. Batteries of the iDive300 case are running low ­ change or recharge them soon. Mode Button Note: The current firmware release does not support the "Photo" mode on iPod models with a touch-screen interface For Mask Strap Mounting: Feed mask strap through the slits in each slot of the clip. To Remove Mask Clip: For touch-screen iPod models it's necessary to use the mode button to cycle between the various iPod menus/modes (i. e. Photo menu (not currently supported), Video menu, Audio menu, etc. ). The mode button does not function with scroll-wheel controlled iPod models. Starting from the Audio menu, press the "Mode" button - this will transfer the user to the "Photo" menu (not currently supported). Press the "Mode" button again to transfer to the "Video" menu. Press the "Mode" button again to transfer to the "Photo" menu (not currently supported). To return to the "Audio" menu, press the "Mode" button one additional time. Speakers iDive300 speakers feature specially designed clips for attachment to mask straps. The mask clips are removable for users who wish to put the speakers inside a diving hood or under their mask strap. 13 IX. General Storage Procedures For long-term storage, store in a cool dry place out of direct sunlight. CAUTION: The life of a O-ring is typically one (1) year. Contact H2O Audio for spare O-rings and silicone grease. Always remember to reinstall the O-ring before next use. Do not expose the case to extreme heat, such as the inside of a hot car, or in direct sunlight, such as on a beach, or boat deck. [. . . ] A: The iDive300 has an internal amplifier to reproduce audio down to depths of 300 feet. The water pressure at this depth requires a powerful amplifier to drive the sound through the headphones. At full depth, the force of the sound waves is mitigated by the water pressure. At lesser depths or on the surface, this loud volume can damage your hearing. [. . . ]