User manual H2O AUDIO OCEANIC DV

[. . . ] The clips are removable for users who wish to put the speakers inside a diving hood. NOTE: The speakers are rigidly fixed to the housing and should not be disassembled from the housing for any reason. FCC CERTIFICATION: THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE, RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Note: This equipment has been tested and found to comply with the limits for a Class B digital service, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] CAUTION: Only use the O-ring grease provided with your housing. 4. Before replacing the O-ring, visually inspect the groove in the lid and the contact surface for hair, sand, lint, or other debris and wipe clean as necessary. Also, check the contact surfaces scratches, blemishes, or other imperfections. If an O-ring contact surface is damaged, do not use the housing. It is very possible the housing will flood and damage the electronics. Install the O-ring with the flat side down; making sure that it is seated uniformly, with no twists or loose areas. Be careful not to stretch the O-ring unnecessarily. GENERAL STORAGE PROCEDURES: For long-term storage, remove O-ring and store out of direct sunlight. If the O-ring will not be used for a long period of time, remove from it the housing and store in a plastic bag out of direct sunlight. If the Oring is stored in a dry environment for a long period of time, it will develop cracks and become unusable. CAUTION: The life of an O-ring is typically one (1) year. Contact your supplier for spare O-Rings or a maintenance kit. Always remember to reinstall and lubricate the main housing O-ring before next use. Do not expose the housing to extreme heat, such as the inside of a hot car, or in hot direct sunlight, such as a beach, or boat deck. Doing so may cause damage and subsequent flooding. CAUTION: Do not store housing in following environments: * Solvents or other chemical fumes * High humidity * High Ozone * Extreme temperature fluctuations Storage in such conditions may lead to housing damage and leakage. Rinse the EXTERIOR of the system in fresh water after EACH use: 1. Make sure the housing is sealed and closed 2. Soak in clean fresh water for 30 minutes. Rinse the entire system with freshwater 4. Then completely dry the entire exterior of the system using a clean soft cloth. Strong detergents, soaps, and chemicals MUST NEVER be used to clean the system. If you must use a soap, it should be a very diluted. HOUSING OPERATIONS: Button 1: MP3 ON/OFF/Play/Stop Button 3: Mode Lever 1: Navigation Button 2:Memory/EQ Open the Housing STEP 1: Pull out the Tab STEP 2: Rotate the Dial counterclockwise CAUTION: If the housing has been subjected to pressure and become `tighter' and more difficult to open than usual, in this case, rotate the dial a little more strongly than usual. FORWARD BACKWARD Volume DOWN + O N CLOS PE Volume UP E TAB Button 5: Menu Closing the Housing STEP 1: -Rotate the Dial Clockwise until both halves of the housing are fully closed. [. . . ] DES will not be held responsible for any agreements orally or in writing with the exception of those expressly included in this warranty statement. This warranty registration card and the terms contained herein supersede all statements contained in any and all owner's guides, instruction cards, or other equipment literature or catalogs. In no event will DES, its Authorized International Distributors, and Authorized Dealers be held responsible or liable for any personal injuries resulting from the use of the covered equipment, or for any other damages, whether direct, indirect, incidental, or consequential; even if DES has been advised of such damages. Warranty does not extend to any damages that may occur to the MP3 players. RETURNING FOR SERVICE: Prior to any return, a Return Authorization (RA) number must be attained. [. . . ]