User manual H2O AUDIO S5-1A3

[. . . ] If it is out of alignment, twisted or dirty you will cause damage to, or destroy your iPod. » If you have any concerns or issues with a H2O Audio product do NOT contact your local retailer. Please contact H2O Audio: 1. 800. 708. 6080 858. 623. 0339 support@h2oaudio. com www. h2oaudio. com H2O Audio 11211 Sorrento Valley Rd. Installing and Replacing Housing Rails CAUTION: For the iPod ( with video ) 60Gb and 80Gb to fit into the housing you must replace the thick clear rails that come installed in the housing with thin grey rails which are included in this bag. *If you are unsure which rails you need or if you need rails please contact H2O Audio* 1. [. . . ] Installing the iPod into the Housing Installing the iPod 1 1 1. Slide latch button towards the unlock icon. 1. Compress the lid to the base if the latch can does not clear the lid hooks. 1. Gently snap the player into the stereo jack in the housing. 2 2. While holding the latch button towards the unlock icon, push up on the side of the latch. Squeeze both sides of the housing together 2 audio jack. Verify that the player is completely plugged into the audio jack. 2. Snap the latch downwards to lock in place. T-Seal Removing the iPod 1. Slide the player off of the stereo jack. Player will slide up the ramps at the bottom of the housing. 3 3. Compress the lid to the base if the latch does not clear the lid hooks. 3 3. Verify the lid and latch are closed and the button is positioned on the icon prior to entering the water. To ensure the T-Seal is fully seated in the base of the housing, firmly squeeze both sides (the base and lid) of the housing together after each insertion of the player. Always check to make sure the latch is closed and locked prior to use. 2. Rotate the housing to drop the player into your hand. NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the housing lid to completely seat the T-Seal. S5 - 70 20060210 8. Connecting the Headphones The SealTight Connector is what keeps your audio connection safe and dry underwater. It is designed specifically to create a seal around the H2O Audio Series Waterproof Headphones (sold separately). Using any other headphones will not have a complete waterproof connection, and reduces the waterproof rating to water-resistant. TM 9. Commander Scroll Wheel Control The Commander Scroll Wheel Control is a waterproof assembly, which allows you to maintain complete control over the iPod's Click wheel functions. Refer to iPod Instruction Manual for complete details of how to use the player. TM TM 10. General Storage Procedures For long-term storage, store in a plastic bag out of direct sunlight. CAUTION: The life of a T-Seal is typically one (1) year. [. . . ] In no event will H2O Audio, its Authorized International Distributors, and Authorized Dealers be held responsible or liable for any personal injuries resulting from the use of the covered equipment, or for any other damages, whether direct, indirect, incidental, or consequential; even if H2O Audio has been advised of such damages. Warranty does not extend to any damages that may occur to the iPod or loss of any data. H2O Audio Waterproof Headphones (required for use underwater) IMPORTANT WARNING AND DISCLOSURE: THOSE USERS THAT ELECT TO UTILIZE THIS SYSTEM AT, OR NEAR, THE WATER'S SURFACE, MUST MAINTAIN SAFETY AWARENESS OF MOVING WATER CRAFTS. ALWAYS MAKE SURE TO HAVE THE AUDIO PLAYER VOLUME TURNED TO ZERO AND THE SPEAKERS AWAY FROM THE EARS WHEN TURNING ON THE H2O AUDIO UNIT. IF THE VOLUME LEVEL IS NOT ZERO WHEN THE H2O AUDIO IS TURNED ON, IT MAY CAUSE EAR INJURY DUE TO A SUDDEN BURST OF VOLUME. [. . . ]