User manual H2O AUDIO S9-1A3

[. . . ] To install a new or clean T-Seal, start at any corner, push the T-Seal into the corner and run your finger along the T-Seal pushing it into the Housing Contact Surface. 4. Ensure the T-Seal is seated properly in all four corners and the Housing Contact Surface. How to install / replace the T-Seal 5. The lid should close without any resistance. If you experience any resistance when closing the housing please call customer service immediately at 1. 800. 708. 6080 x213 before using your housing. Cleaning & Storing the T-Seal It is extremely important that you keep the T-Seal clean & free of sand, dirt, hair, lint, and other debris. [. . . ] Gently snap the player into the audio jack. Verify the player is completely plugged into the audio jack. Prior to use, verify: Do NOT use if: 2. While holding the latch button towards the unlock icon, push up on the side of the latch. 2. Pull the latch towards the housing and snap in place. 1. T-Seal is aligned properly in the Contact Surface of the lid prior to closure. 1. T-Seal is twisted, or out of alignment during closure. Compatible with 2nd Gen iPod nano 2. T-Seal and contact surface have been cleaned as necessary using a soft, lint-free cloth. 2. T-Seal and Contact Surfaces have any dirt, lint, hair, and/or other debris. Removing the iPod 1. Slide the player off of the stereo jack. Now the player can slide straight out of the housing. 3. 3 T-Seal and Contact Surface are free of scratches and other imperfections. 3. You see scratches or imperfections on the T-Seal or Contact Surfaces. 3. Verify the lid and latch are closed 3 3. Unhook the buckle from the base. and the button is positioned on the icon prior to entering the water. DO NOT USE SILICONE GREASE as this will damage the seal. To ensure the T-Seal is fully seated in the base of the housing, firmly squeeze both sides (the base and lid) of the housing together after each insertion of the player. Always check to make sure the latch is closed and locked prior to use. If you have any questions or doubts, please contact H2O Audio Customer Support NOTE: Do not disturb the T-Seal during removal of the player. If the T-Seal is moved, Please use the housing lid to completely seat the T-Seal. S9 - 70 20061013 8. Connecting the Headphones The SealTight Connector is what keeps your audio connection safe and dry underwater. It is designed specifically to create a seal around the H2O Audio Series Waterproof Headphones (sold separately). Using any other headphones will not have a complete waterproof connection, and reduces the waterproof rating to water-resistant. TM 9. Commander Scroll Wheel Control The Commander Scroll Wheel Control is a waterproof assembly, which allows you to maintain complete control over the iPod's Click wheel functions. Refer to iPod Instruction Manual for complete details of how to use the player. TM TM 10. General Storage Procedures For long-term storage, store in a plastic bag out of direct sunlight. [. . . ] H2O Audio will not be held responsible for any agreements orally or in writing with the exception of those expressly included in this warranty statement. The warranty registration card and the terms contained herein supersede all statements contained in any and all owner's guides, instruction cards, or other equipment literature or catalogs. H2O Audio is a registered trademark of Diver Entertainment Systems, Inc. Apple and iPod are registered trademarks of Apple Computer Inc. [. . . ]