User manual HAIER 50FREE-2

[. . . ] Fully Automatic Washing Machine User's manual This manual is for 50FREE-1 Please read this manual carefully before using. Special number:0030805887A CONTENTS Specification Names of the parts Safety precautions Installation and adjustment Install the water inlet hose Preparation before washing Put in the laundries Usage of the detergent Close the top lid Use the operation buttons Finish washing Disposal after washing Trouble-shooting answer to question Packing list the 2nd cover 1 2 4 6 8 9 9 9 10 13 14 15 16 Specification table Water level/Water quantity (about) Water Injection pressure Rated washing / spinning capacity 0. 03MPa ~ 1MPa 5. 0kg/5. 0kg Packing list Names of the parts Top lid component Control pannel Liquid detergent inlet Quantity User's manual Warranty card Water inlet hose The side of connection between the water inlet hose and the washing machine Inner cove component Detergent box Attachment block (2 pieces) Handle Water inlet valve One One One Filter frame Balance ring Lint filter Inner tub Pulsater Front control board Water absorption cushion Power cord Drain hose frame Drain hose Back cover The side of connection between the jointer of the water inlet hose and the water faucet Cabinet Base frame Adjustable leg film Adjustable leg Fixed leg (3 pieces) Bottom plate One Inside in inner tub of washing machine Meaning and description of the symbols Inner cover component One Inside in inner tub of washing machine Warning sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents. Automatic washing machine One Forbidden sign Contents marked with that symbol are actions forbidden to perform. Performing of those action may result in damage of the machine or influence the personal safety of the users. 1 Safety precautions Please plug the power plug on special receptacle. [. . . ] If you need to set the washingprocedure to be finished at reserved time, please push the " reserve " button to set the reserve wash program. Refer to reserve button in Page 11 for selection. Confirm the operation of reserve program Adjust the Installation position The distance that washing machine away from wall should be above 20mm. The largest allowed slope of the shank base of the machine is 2 . The slanting or rough ground will result in unstable running or stoppage of the machine. The full procedure is controlled automatically. The drainage shall be smooth with the drain hose. 1. put the drain hose up to suitable position (Do not 2. Do not step on or press the drain hose. put it on ground. ) Notes: The highest point of drain pipe shuold be higher than the water level of washing tub for avoiding to siphon phenomenon during drain. 3 Push "soak", "wash", "rinse/sterilize", "spin" button to select suitable procedure program So ak Wash Rins e Sp in Sterilize 0. 8m<H<1. 2m Attention Even there's no water in the tub, a certain period is required before spin starting. Separate the laundries that are not colorfast from other laundries in washing. The pulsator will not rotate unless the water is filled to selected water level. 12 5 Install the water inlet hose Reserve, remain time digitron It displays "--" during detecting. It displays remained reserve time (hour). It displays abnormal symbol in abnormal situation. (See to Page15) "Power" button Push the "power" button to switch on the power. Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes. 1. Attach the water inlet hoses to the water faucet. ( As figure 1) NOTE: Do not over tighten. Connect the other ends to the water inlet valve . 42L 45L 39L 32L 26L 18L carpeting Standard Save Air dry ( As figure 2) Figure 1 36L 29L 22L 14L Fibre Wool Superfast "Air- Dry " button Push the "air- d ry" button , then the "air- d ry"indicator light is on, that means the "air-d ry"program is chosen. The purpose is drying laundrie at the same time can dry the outer tub and the inner tub , which can avoid growing mildew on the outer tub and the inner tub. The max drying capacity of the fibre laundrie is 1. 5 kg. Jointer of the water inlet hose Reserve Water level me Progra y Air-Dr Power Lock Jointer of the water inlet valve Water absorption cushion Figure 2 "Water level" button The washing machine can detect the laundries automatically in standard program. After detection, it will set the water level to suitable value among 4, 6, 8, and 10 automatically. You can also set water level by yourself. [. . . ] Run for about 30s to fully dissolve the Powder. Then push the"start/pause" button. Push the "start/pause" button again. Prepare warm water of 30 C and container. [. . . ]