User manual HAIER ADP8152

[. . . ] - The carpet must obstruct the opening when the appliance is in stalling on the ground with carpet. - If the supply cord is damaged , it must be replaced by a special cord or assembly available from the manufacturer or its service agent. This appliance complies with the following EEC DECLARATION OF CONFORMITY The manufacturer of the product/s described herein, to which this description refers, declares on its sole responsibility that the product/s meet the relevant fundamental satety, health and protection requirements of the relevant EU guidelines and that corresponding test reports are available for examination by the relevant authorities and can be requested from the seller of the appliance , especially with regard to CE Declaration of Conformity issued by the manufacturer or with the manufacturer's approval. Moreover, the manufacturer declares that the parts of the appliance described in this user manual, which come into contact with fresh food, do not contain any toxic substances. Please keep this handbook for future reference or for anyone else who may use this appliance. directives: -73/23/EEC of 19/02/73(Low Voltage)and subsequent modifications; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications. - Carefully dispose of the packing material. [. . . ] - Silverware should be placed in the silverware basket with the handles at the bottom;if the rack has side baskets, the spoons should be located individually into he appropriate slots. Especially long utensils should be placed in the horizontal position at the front of the upper rack. Load for 12 Standard Settings Important C A Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spotting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. B C F How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter 1 2 dishware, such as glasses, coffee and tea cups and saucers, as well as plates, small bowls and shallow pans(as long as they are not too dirty). Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height . B) 3 4 C Notice:To facilitate closing the cover, remove any excess detergent on the edges of the dispenser. Fig. A Fig. B . 4. . 5. Turning on the Appliance Wash Cycle Table Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher"). - Pour in the detergent (see the section entitled, "Salt, Dergent and Rinse Aid"). - Turn the knob located on the right of the control panel in the clockwise direction until the number or symbol for the cycle set ting is aligned with the reference mark(see the section entitled, "Wash Cycle Table"). - Press the ON-OFF botton, and the ON-OFF light will turn on. At this point, the wash cycle will begin. 4 Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. 5 1 2 3 Cycle Eco Button RAPID Button Cycle Selection Information Desciption of Cycle Detergent Rinse Aid Normal Wash 6 Pre-wash with hot water. Very dirty dishes, pots and Extended wash at 65 pans. (not to be used with Rinse with cold water. delicate items) Rinse with hot water at 70 Drying. Normally dirty dishes, pots Extended wash at 55 and pans. Standard daily Rinse with cold water. Normally dirty dishes, pots Extended wash at 65 and pans without dried on Rinse with cold water. 15g "1/2 load" Button This button(see "close-up View - Control Panel", letter"H") make it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and eletrical energy. "Rapid" Button This button(see "close-up View - Control Panel", letter "I") , when pressed with wash cycle 4(glassware) make it possible to run the wash cycle at a lower temperature (50 ) and eliminates the drying phase. . 6. . 7. Energy Saving Tips Cleaning and Special Maintenance Filter Assembly - It is important to try and run the dishwasher when it is fully loaded to save on energy. In order to prevent odors from forming and food from caking onto the dishes, you can run the hold cycle. - Choose the right wash cycle: the choice of cycle depends on the type of dishware, cookware and utensils being washed and how dirty they are. - Use the right amount of detergent: if you use too much detergent, the result will not be cleaner dishes, but, rather, a greater nega tive impact on the environment. - There is no untility in rinsing dishes , cookware and untensils before placing them in the dishwasher. For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason , it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the"A"semi-circular filter and cup under running water. To remove the filter assembly, pull on the cup handle in the upward direction. The entire filter assembly (made up of the "A" semicircular filter and the"B" fine filter)should be cleaned at least once a month. To clean the filter and the fine filter, use a cleaning brush . Then, reassemble the filter parts as shown in the figures below and reinsert the entire aseembly in the dishwasher, positioning in its seat and pressing downward. The dishwasher must not be used without the filters. Improper replacement of the filters may reduce level of the appliance and damage dishes and utensils. A Cleaning the Spray Arms It may happen that food particle become encrusted on the sprayer arms and block the hole (see "Close up view [interior]", letters CF ). Check the sprayer arms periodically and clean them when needed. B How to Keep Your Dishwasher in Shape Troubleshooting After Every Wash After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Moving the Appliance If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be positioned on its back. [. . . ] e) The guarantee in no way affects your statutory. Refit the fuse cover BLUE BROWN YELLOW & GREEN "NEUTRAL" (N) "LIVE" (L) "EARTH" (E) Procedure when Reporting A Fault 1. Give full name, address including post code, home telephone number and business telephone number if appropriate. Quote sales receipt number, make and model of faulty appliance. [. . . ]