User manual HAIER AF12AS1ERA

[. . . ] Please read this operation manual before using the air conditioner. Keep this operation manual for future reference. Please be subject to the actual produce purchased the above picture is just from your reference ON/OFF button Push once to start operation, push once again to stop it. operation is set to AUTO , air flow is set to AUTO fan. [. . . ] Set the wind speed change when sleeping If the wind speed is high or middle before setting for the sleep, set for lowing the wind speed after sleeping. Before inserting power into receptacle, check the voltage without fail. A receptacle shall be set up in a distance where the power cable can be reached. Place, robust not causing vibration, where the body can be supported sufficiently. Place, not affected by heat or steam generated in the vicinity, where inlet and outlet of the unit are not disturbed. Place, possible to drain easily, where piping can be connected with the outdoor unit. Place, where cold air can be spread in a room entirely. Place, nearby a power receptacle, with enough space around. Place where the distance of more than lm from televisions, radios, wireless apparatuses and fluorescent lamps can be left. In the case of fixing the remote controller on a wall, place where the indoor unit can receive signals when the fluorescent lamps in the room are lightened. Attention must be paid to the rising up of drain hose More than 60 cm more than 10cm Make a hole of 70 mm in diameter, slightly descending to outside the wall Install piping hole cover and seal it off with putty after installation Coat the flaring seal face with refrigerant oil and connect pipes. Cover the connection part with heat insulation materials closely, and make sure fixing with adhesive tape Hold the front panel by the tabs on the both sides and lift it until it stops with a click. Indoor/outdoor electric cable and drain hose must be bound with efrigerant piping by protecting tape. Cut away, with a nipper, the lid for piping according to the piping direction and then bend the pipe according to theposition of wall hole. When bending, be careful not to crash pipes. Connect beforehand the indoor/outdoor electric cable, and then pull out the connected to the heat insulation of connecting part specially. Remove the front panel, then use two fastening screws to fix the unit on the floor. Once refrigerant piping and drain piping connections are complete, fill the gap of the through hole with putty. Attach the front panel and front grille in their orginal positions once all connections are complete. Draw pipes and the drain hose, then fasten them with the adhesive tape In case of left side piping, cut away, with a nipper, the lid for left piping. In case of left-rear piping, bend the pipes according to the piping direction to the mark of hole for left-rear piping which is marked on heat insulation materials. Insert the drain hose into the dent of heat insulation materials of indoor unit. [. . . ] Noise is heard If the power supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. If the fuse of indoor unit on PC board is broken, please change it with the type of T. If the fuse of outdoor unit is broken, change it with the type of T. The wiring method should be in line with the local wiring standard. [. . . ]