User manual HAIER CHLF103Q

[. . . ] see the grounding instructions in the installation section. Never unplug your water dispenser by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet. Repair or replace immediately, all electric service cords that have become frayed or otherwise damaged. [. . . ] Remove the cap from the water bottle first. Lift up the water bottle and quickly place it into the water receptacle. DO NOT plug in the water dispenser until you have checked that water flows out of both faucets when the hot and cold water release levers are pressed. Never turn on the water dispenser without water. Doing so may cause the unit to catch fire or malfunction. Check that water flows out by pressing both the hot and cold water faucets one at a time. Plug the power cord into an 115volt / 60 Hz outlet. To activate the water heater and cooler, press the hot water and cold water switches to the ON position, the switches should be lit. This water dispenser maintains instant hot and cold water for your cooking and drinking needs. Press the button down to release the water flow. Note: The hot (red) water button is equipped with a child safety lock to prevent accidental spilling of hot water. Do not use electrical appliances inside the food storage compartments of appliance, unless they are of the type recommended by the manufacturer. ⷠTo avoid a hazard due to instability of the appliance, it must be fixed in accordance with the instructions. Caution: Before using any cleaning product, always read and follow the manufacturer's instructions and warnings to avoid personal injury and/ or product damage. Note: It is best to clean the dispenser and its surrounding area when replacing the empty bottle with a new one. This way you can move the unit easily without the weight of the bottle. Before cleaning, place a dust cover on top of the water guard to prevent dust and debris from going into the dispenser while cleaning. ⷠPrepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm water. Use a sponge or a soft cloth dampened with the cleaning solution to wipe down the unit. Always unplug the unit before cleaning to avoid electric shock. Failure to do so may result in death or injury. Wipe with clean warm water and dry with a soft cloth. [. . . ] if water dispenser operation is noisy: · Make sure the water dispenser sits on a level surface. If the dispenser is noisy after its first use, unplug it for half an hour and try again. if the condenser becomes too hot: · When the compressor is working, it is normal for the condenser to be hot. If you are concerned that the temperature is too high, check to see that there is enough room around the water dispenser to allow proper ventilation. [. . . ]