User manual HAIER CTV14181

[. . . ] See the grounding instructions in the installation section. Never unplug your water dispenser by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet. Repair or replace immediately, all electric service cords that have become frayed or otherwise damaged. [. . . ] 2, attach the side panels to the back panel. Secure the base to the upper section with the provided screws. Place the front panel on the base panel. Make sure that the hole on bottom left of the door is aligned with the forelock. Attach the top panel with the provided screws as shown, making sure that the forelock is properly in place on the upper left side of the door and the top panel is aligned with the forelock. Place the middle panel inside the storage compartment as shown. The water dispenser can now be set on the unit. 7 English a. b. c. d. Note: Your units come with a bottle secure bracket as seen in figure A. Use the bracket shown above to keep the water bottle stable and tightly secured. This will help when the water level is low in the bottle and avoid bottle wobbling. To use simply place the bracket inside the water bottle holding receptacle as shown in figure B. Now place the water bottle on the cooler as shown in figure. Remove the plastic shelf to store taller items. Removable Drip Tray The spilled water in the drip tray must be removed regularly and cleaned properly to avoid any bacteria and residue build-up. To remove it gently, lift the tray up. 9 English PROPER CARE AND CLEANING Caution!Before using any cleaning product, always read and follow the manufacturer's instructions and warnings to avoid personal injury and/or product damage. Note: It is best to clean the dispenser and its surrounding area in between replacing the empty bottle with a new one. This way you can move the unit easily without the weight of the bottle. General · Before cleaning, place the dust cover on top of the water guard to prevent dust and debris from going into the dispenser while cleaning. WARNING!Always unplug the unit before cleaning to avoid electric shock. Failure to do so may result in death or injury. · Prepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm water. Use a sponge or a soft cloth dampened with the cleaning solution to wipe down the unit. · Wipe with clean warm water and dry with a soft cloth. [. . . ] If water is dripping from the dispenser onto the floor: · The water bottle may have small pinholes. · The drain plug in the rear may be improperly fastened. Check that the soft rubber seal is not torn or damaged. · The drip tray at the bottom of the cooling compartment may be full of water. [. . . ]