User manual HAIER DDW300S

[. . . ] Not even if the area in which it is installed is covered by a roof. - Do not lean or sit on the door when it is open, as this could overturn the dishwasher. - If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket. Then, refer to the "Troubleshooting". [. . . ] Close the door and after a few seconds, The wash cycle will begin. Read the paragraph entitled, "Cancelling or changing a cycle while underway. "The end of the cycle will be signalled by six beeps, and the indicator light "F" will extinguish. Setting The Start Delay Time Open the door of the dishwasher partially. Press button "J" (see, Close-up View" Control Panel") to delay the starting time for a wash cycle. . 1st press, "2h" indicator comes on, the cycle will start in 2 hours. . 2nd press, "4h" light indicator comes on, the cycle will start in 4 hours. . 3rd press, "6h" light indicator comes on, the cycle will start in 6 hours. . 4th press, "2h" and "6h" light indicators come on, the cycle will start in 8 hours. . 5th press, "4h" and "6h" light indicators come on, the cycle will start in 10 hours. Very dirty dishes, pots and pans. (Not to be used with delicate items) Intensive Pre-wash with hot water. Extended wash at 70 K Rinse with cold water. Rinse with hot waterK Drying. 30g Pre-wash with cold water. Extended wash at 50 Rinse with cold water. Extended wash at 50 Rinse with cold water. Economic, fast cycle to be used for delicate items which are sensitive to higher. Run immediately after dishes are K . 5+25g ERF Normal Wash Cancelling or changing a cycle while underway. . . Premise: A cycle that is underway can only be changed if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). To change the cycle currently underway, open the door, press the "G" programming button and hold it in for about 5 seconds. Once the cycle has been cancelled, the dishwasher will emit a short acoustic sound and the relative indicator light will turn off. To set a new wash cycle, follow the instructions contained in the paragraph entitled, "Setting and Starting a Wash Cycle. " . 6th press, "2h" , "4h" and "6h" light indicators come on, the cycle will start in 12 hours. . last press, all light indicators will extinguish and you can reset. [. . . ] If it is level, it will help ensure proper performance. Drain Hose Connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, Or let it run into the sink, making sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see fig. 3). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. Cold Water Connection Connect the cold water supply hose to a threaded 3/4 (gas) connector, making sure that it is fastened tightly in place (see fig. 2). Some models are fitted with an "Aquastop" water supply hose (see fig. 1) in which the small filter is already housed in the threaded end. [. . . ]