User manual HAIER DW12-CBE6 IS

[. . . ] ENGLISH The symbol on the product or on its packaging indicates that this product Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. [. . . ] To modify or cancel the carrying out of a washing cycle (being the door opened), it's necessary to reset the previous programming, by holding pushed the programme selector button "G" for at least 3 seconds, and the buzzer emits one short warning signal. if the reset operation was successful , a drain phase is started. Once the drain phase is ended, the dishwasher stands waiting for a new programming. Premise: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). to change the cycle currently underway , open the door and press the ON-OFF button "A" , follow the instructions contained in the paragraph entitled , "Starting a wash cycle " , "Setting and Starting a Wash Cycle". To set a new wash cycle, follow the instructions contained in the paragraph entitled, "Setting and Starting a Wash Cycle". A) During the delay period, none of the settings can be modified. If necessary, they can be cancelled by pressing press the ONOFF button "A" located on the control panel. B) If the door is opened during the delay period, the clock will stop the countdown. How to use the upper rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height by using the knobs located on both sides of the rack itself (see fig. Adjust the upper basket to the higher level and you have more space to accommodate those taller pans and trays in the bottom basket. "3 in 1" Button This button (see "Close-up View - Control Panel", letter "C" ) , is C used for the customer useing the " 3 in 1" detergent. When using "3in1"combination products, the rinse-aid and salt lights are no longer useful. It may be helpful therefore to switch the rinse aid off (please note that only some dishwashers have this facility) and selecting the lowest possible setting for water hardness. If you decide to switch to the use of a standard detergent system we advise that you: 1:Refill both the salt and rinse aid compartments. 2:Switch the waterhardness setting to the highest possible position and run for three normal cycles without a load. 3:Readjust the waterhardness setting again according to the conditions for your region (For more information please refer to your instruction manual). Lean tall glasses and those with long stems against the shelf-not against other items to be washed. [. . . ] If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and damage the appliance. Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. The water supply to the appliance can also be connected to the house's hot water line (centralised system, heating system), as long as it does not exceed a temperature of 60 . [. . . ]