User manual HAIER DW12S

[. . . ] - During installation the power cord must not be bent or flattened excessively. - If the appliance is not operating properly, disconnect the appliance from the power supply. Warning: Dishwasher detergents can be extremely dangerous if swallowed. Avoid contact with skin, eyes and keep children away from the dishwasher when the door is open. Check that the detergent receptacle is empty after completion of the wash cycle. [. . . ] If drops of water remain on the dishes or spotting occurs, the dosage adjuster should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjuster to a lower setting. CA C NOTE: Remove excess detergent from the edges of the dispenser before closing the lid. F . 3. Loading the Dishwasher Before placing the dishes in the dishwasher, remove the larger food particles to prevent the filter from becoming clogged. If the pots and pans have baked-on food that is extremely hard to remove, we recommend they are soaked before washing. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher. Lower Rack Upper Rack The lower rack Place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. - Deep pots should be tilted to allow the water to flow out. 1 Load for 12 Standard Settings The upper rack The upper rack is designed to hold more delicate and lighter dishes, such as glasses, cups and saucers, plates and small bowls. - Position the dishes so that they do not move by the spray of the water. To adjust the height of the upper rack, rotate the caps located on the end of the rack guide rails to the side, remove the rackcompletely and refit using the alternate set of wheels (see fig. B). Adjust the upper basket to the higher level to allow more height in the bottom basket for large items. 3 2 4 fig. A fig. B . 4. Turning on the Appliance Starting a wash cycle - Make sure that the appliance is plugged in and switched on. - Make sure that the water supply is turned on. - Load the detergent (see the section entitled, "Detergent and Rinse Aid" on page 3). - Turn the timer dial located on the right of the control panel in a clockwise direction until it points to the number or symbol of the cycle required (see the section entitled, "Wash Cycle chart" on page 7). - Press the Power button, the Power light will turn on and the wash cycle will begin. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Cancelling or changing a wash cycle setting A cycle that is underway can only be changed if it has been running for a short time. Otherwise, the detergent may have al- If you forget to load some of the dishes The wash cycle can be paused by pressing the Power button. You can then load additional dishes and turn the appliance back on. The cycle will continue from where it left off. ready been used and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent" on page 3). [. . . ] The entire filter assembly (made up of the semicircular filter "A" and the fine filter "B") should be cleaned at least once a month use a soft brush. To reassemble, insert the entire assembly into the dishwasher, locate it correctly in its seat and pressing downward. The dishwasher must not be used without the filters. Improper replacement of the filters may reduce the performance of the appliance. Cleaning the Spray Arms Food particles may become encrusted on the spray arms and block the hole (see "Close up view [interior]" on page 3, letters C-E ). [. . . ]