User manual HAIER DW12-D2147FBIS

[. . . ] Com manuals search engine Safety Is a Good Habit to Get Into NOTICE Carefully read the instructions contained in this manual, as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance. This appliance complies with the following EEC directives: - 73/23/EEC of 19 February 1973 (Low Voltage) and subse quent modifications; - 89/336/EEC of 3 May 1989 (Electromagnetic Compatibility) and subsequent modifications. - Carefully dispose of the packing material. - After removing the packing, check to make sure that the appliance is not damaged. [. . . ] At the end of the delay time, the indicator will turn off and the cycle will start. load for 12 Standard Settings (for IEC-EN 50242 tests) ton "G". Each time it is pressed, one of the cycle indicator lights "F" will begin to blink in succession. Choose the wash cycle you feel is most appropriate for the type of dishes that need washing (consult the wash cycle table contained in this manual, especially when first using the appliance). Close the door and then the wash cycle has begun and cannot be modified. If necessary, read the paragraph entitled, "Cancelling or modifying a cycle while underway. "The end of the cycle will be signalled by six acoustic sound, and the indicator light "F" will turn off. B Cancelling or modifying a cycle while underway Premise: A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). NOTE: a) During the delay period, none of the settings can be modified. If necessary, they can be cancelled by pressing press the ONOFF button "A" located on the control panel. B) If the door is opened during the delay period, the clock will stop the countdown. It will start again when the door has been closed. How to use the upper rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). - Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height by using the knobs located on both sides of the rack itself (see fig. Adjust the upper basket to the higher level and you have more space to accommodate those taller pans and trays in the bottom basket. To change the cycle currently underway, open the door and fig. D press the ON-OFF button "A", follow the instructions contained in the paragraph entitled, "Starting a wash cycle ", "Setting and Starting a Wash Cycle". Wash Cycle Adjustment Buttons 1/2 Load Button This button (see" Close-up View-Control Panel", letter "C") makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load, This will allow you to save on water and electrical energy. It cannot be used with the heavy duty wash cycles. [. . . ] Use the special plastic support that comes with the appliance (see fig. The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. Cold Water Connection Connect the cold water supply hose to a threaded 3/4 (gas) connector, making sure that it is fastened tightly in place (see fig. If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. [. . . ]