User manual HAIER DW9 TFE3ME-F

[. . . ] Getting to know your dishwasher How to fill the salt How to fill rinse aid How to fill the detergent dispenser Not suitable for the dishwasher How to keep your dishwasher in shape If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out. ensure that the domestic wiring is properly earthed. [. . . ] Pull out the rack to load the dishwasher. How to use the lower rack We recommend that you place the most difficult to clean items on the bottom rack: pots, pans, lids, serving dishes and bowls, as shown in the figure to the right. It is preferable to place serving dishes and lids on the sides of the racks in order to avoid blocking the rotation of the top spray arm. Must always be placed face down (see fig. Deep pots should be slanted to allow the water to flow out. The silverware basket can not be doubled (see fig. The values can vary considerably according to: Close the door after loading the appliance. After 3 seconds the appliance emits a short warning signal, and start the programme , the state indicator "A" blinks . Six beeps will indicate that the wash cycle has finished and the state indicators "A" light. switching the dishwasher OFF Several minutes after the programme has ended: Set On-Off button to Off Open the door . notice: When the appliance is already underway press the button "B" for 3 seconds, all of the settings will be cancelled. There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may open due to expansion. delayed start programming You can delay the start of a programme in increments of 1 hour up to 24 hours. Close the door after loading the appliance. Immediately press the Delayed Start button " F ", the delayed start indicator " E " blinks, the remaining time indicator " G " changes to " ". Press the Delayed Start button for 2 seconds until the numerical display show the required delay. To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator " E" goes out. After 3 seconds the delayed start indicator " E " blinks, the time-remaining indicator " G " will blink and decrease , the programme will start until the delayed start indicator " G " goes out . [. . . ] - Too much salt was spilt while filling container. Glasses become clouded and discoloured; coating cannot be wiped off Unsuitable detergent was used. Smears left behind on glasses and cutlery; glasses have acquired a metallic appearance Amount of rinse-aid set too high. Width Depth Height Capacity Mains water pressure Power voltage Maximum current intensity Total absorbed power Old appliances still have some residual value. [. . . ]