User manual HAIER DWE-5212

[. . . ] It is very important to your security and correct operating the machine. 2. Do not step on or press the drain hose. 3. If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly. 4. IF extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall be not less than 30mm, and the length shall be not exceed 1. 5m. Install the water inlet hose; Select the water level Insert the water inlet hose into the water-filling entrance on the control panel directly. (pull it out to dismantle it) Water inlet hose Select water level according to the quantity of the laundries. [. . . ] Spin Foam-removing spinning Fill water for about 1 minutes Spin for about 1~2 minutes Remove the detergent liquid remained The effect is best when the laundries quantity is below 80% of the rated value. Preparation before washing Using process Preparation before washing 1. Connect the water inlet hose. 2. Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe. 3. Put down the drain hose . 4. Slanting or uneven ground may result in unstable working or abnormal noise. Please make the machine stand horizontally. Pay attention to followings before washing the laundries Confirm if there's special requirement for the laundries. Clear the pocket. Take out the coins , sand, hairpins etc. Fasten the buttons and zippers. The quantity of the laundries shall not exceed the rated value. The big laundries like the jeans shall be put in loosely. When the pulsator is running , the buttons of the laundries may cause noise. For the sake of discretion, please put the laundries with buttons into other laundries. The musts in washing Using process The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this machine is 9. 0 kg. (Figure 3) 5. Select the washing time Select the washing time according to the laundries. (Figure 4) 6. After washing, the buzzer will ring. Set the "WASH SELECTOR" at "DRAIN". (Figure 5). STANDARD DRAIN WASH SELECTOR Figure 3 OFF SILK WOOL WASH TIMER COTTON LINEN Figure 4 STRONG STANDARD DRAIN WASH SELECTOR Figure 5 Using process Midway spinning 1. Put the laundries into the spin tub evenly and smoothly. Please put in the gland properly even if the laundries quantity is small. Push Gland Push laundries Proper Theslanting are Proper No gland (2) Close the inner and outer cover of the spin tub. (3) Spin for 1-2 minutes. Outer cover of The spin tub Inner cover of The spin tub 3. Run the foam-removing spinning. (1) Open the outer cover of the spin tub. (2) Set the water-filling selector control rod at the "SPIN" side. If the water quantity filled is too large, the water may flow out from the wash tub side. Please twist the water tap to limit the water filling. (3) Close the outer cover of the spin tub. Spin for 1-2 minutes. WASH SPIN Using process Rinsing Rinse with stored water (Repeat the midway spinning and rinsing with stored water for 2-3 times) 1. Select suitable current according to the laundries. 2. [. . . ] Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub and the inner/outer cover of the spin tub for some time (about one hour), then close them. Alcohol Petrol Thinner Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. [. . . ]