User manual HAIER EA-1770EG

[. . . ] FIG 1 A Microwave Oven Instruction for use EA-1770EG EA-2080EG Specific No. :0050502330A DECLARATION OF CONFORMITY 1. For your use safety, before installing this model of microwave oven, please take out the locating spacer rods from the cavity (as illustrated in Figure 1 of the verso), and insert them respectively into the two locating holes at lower part of the cavity rear panel as illustrated, so as to ensure good ventilation between the microwave oven and back wall. (EA-1770EG) The manufacturer of the product/s described herein, to which this description refers, declares on its sole responsibility that the product/s meet the relevant fundamental safety health and protection requirements of the relevant EU guidelines and that the corresponding test reports are available for examination by the relevant authorities and can be requested from the seller of the appliance, especially with regard to CE Declaration of Conformity issued by the manufacturer or with the Manufacturer's approval. Moreover , the manufacturer declares that the parts of the appliance described in this user manual, which come into contact with fresh food, do not contain any toxic substances. Electricity schematic diagram FUSE The Primary interlock switch Curbing motor RELAY HVC Monitoring switch Grill heater Fan motor Lamp L (in) L (out) FA DELAY CIRCUIT AK Rectifier HVD F Magnetron MF MT L N N (in) NE (out) EA-2080EG/EA-1770EG E Thermostat Thermostat TAPI This figure suits the CE/GS certification HVT The door interlock switch RG CPU The secondary interlock switch RW RELAY RELAY FUSE The Primary interlock switch Curbing motor Fan motor HVC Monitoring switch Grill heater Lamp FA AK Rectifier HVD F MF MT EA-2080EG/EA-1770EG Magnetron L N E This figure does not suit the CE/GS certification HVT Thermostat Thermostat The door interlock switch RG CPU The secondary interlock switch RW 28. [. . . ] Place the appliance on an even and non-skid surface. It must be stable enough to easily support the appliance even if the oven contains goods. Leave a space of at least 15 cm between the foremost edge of the worktop and the front of the oven door . You will thus prevent the appliance from tilting forward when the door is open. Install the oven in a place where it is protected against splashing water or dripping liquids. Sunlight and humidity may impair operational safety. Never expose your microwave oven to direct sunlight (overheating hazard). Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers. The following minimum clearances between other objects / walls must be maintained for safety purposes: - Side l/r clearance at least 5 cm - Rear clearance at least 10 cm - Upper clearance at least 30 cm The appliance must not be built into a cupboard. Only use clear water with just a little washing-up liquid for cleaning. Do not under any circumstances use sharp cleaning or scouring agent. Lastly wipe the cabinet dry with a soft cloth. Carefully remove food particles and dirt deposits between the door and cabinet, so that the door always shuts properly and tightly. Under no circumstances should you continue to use the appliance if you have detected any damage on the door seal or on the adjoining surfaces. The same applies to damage detected on the door itself or door hinges. Otherwise hazardous microwave radiation may escape from these locations. This kind of dam, age must be repaired by a trained customer service engineer before you can use your appliance again. Cleaning the inside of the oven Never pour water into the oven interiors . Water may enter the interior of the oven through the air vents and damage the appliance. Moreover serious accidents can ensue due to electric shock. Clean the oven interior thoroughly Particles of fat and food may overheat and potentially cause fire . Moreover food and dirt deposits inside the oven affect the performance of the microwave oven. Use only clear water with a little washing-up liquid to clean the interior of the oven. [. . . ] Follow the instructions of food manufacturer and put the bag in the centre of turntable. During this programme corn will pop and the bag will increase in volume. Be careful when taking out and openi ng the hot bag. This function is for reheating leftover chilled pizza. [. . . ]