User manual HAIER ED60SS

[. . . ] - Do not lean or sit on the door when it is open as this could overturn the dishwasher. - Do not touch the heating element during or after a wash cycle. - If the appliance malfunctions turn off water supply to the appliance and disconnect the plug from the wall socket. Refer to the section entitled, "Troubleshooting". [. . . ] - Deep pots should be slanted to allow the water to flow out. - The silverware basket can be doubled (see fig. A) so that only one section may be used when the silverware load is light. This also makes space for additional pots and pans, and it can also be placed in the upper rack. - Silverware should be placed in the silverware basket with the handles at the bottom. If the rack has side baskets, the spoons should be loaded individually into the appropriate slots. Long utensils should be placed in the horizontal position at the front of the upper rack. Load for 12 Standard Settings How to Use the Upper Rack The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, as well as plates, small bowls and shallow pans. It is recommended that dishes placed in the upper rack are not too dirty . Position the dishes and cookware so that they do not get moved by the spray of water. The upper rack can be adjusted for height by using the knobs located on the sides of the rack itself (see fig. B). 3 4 1 2 fig. A fig. B GB . 4. Turning on the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher" on page 4). - Pour in the detergent (see the section entitled, "Detergent and Rinse Aid" on page 3). - Turn the knob located on the right of the control panel in clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table" on page 7). Cancelling or modifying a wash cycle setting - Press the ON-OFF button, and the ON-OFF light will turn on. At A cycle that is underway can only be modified if it has been this point, the wash cycle will begin. Otherwise, the detergent may have alIf you forget to load some of the dishes ready been used, and the appliance may have already drained The wash cycle can be interrupted by pressing the ON-OFF button. If this is the case, the detergent dispenser must You can then load additional dishes and turn the appliance back be refilled (see the paragraph entitled, "Loading the Detergent" on. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. At the end of the wash cycle When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. on page 3). Press the ON-OFF button, and the ON light will turn off. [. . . ] The connection must be made to the hot water line following the same procedures as those for the connection to the cold water line. Anti-Flooding Protection The dishwasher is equipped with a system that retains leaks within the unit, in order to prevent damage to your home. Levelling the Appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level. The appliance should not be inclined more than 2 . If the appliance is level, it will help ensure proper performance. Cold Water Connection Connect the cold water supply hose to a threaded 3/4 (gas) connector and make sure that it is fastened tightly in place (see fig. 1). If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the water is clear and free of impurities. [. . . ]