User manual HAIER ESA3247

[. . . ] Function Your air conditioner can be set to go on or Your air conditioner has 4 Functions. This can be programmed up t a) COOL Here the air conditioner will operate the 24 hours in advance. 5. 4-Way Air Flow compressor and the desired fan speed set to The air directional louvers let you control give you cold air for your comfort. direction of the airflow to the desired dire b) FAN The You can run the fan without the A/C function airflow can be directed up-down-right s left side. [. . . ] 2) For cool days you may want to run the "FAN" function. Here the fan runs at one of 3 speeds (HIGH fan, MED fan, LOW fan) as desired by you. 3) The removes dehumidify function excess moisture from the air on excessively humid Tr: temperature inside the room. 1) When Tr>Ts+3oF, the compressor will run the fan continuously at the selected speed. 2) When Ts-1oF*Tr*Ts+3oF, the compressor will cycle for 10 minutes on and 6 minutes off 3) When Tr<Ts-1oF, the compressor will shut off. The dehumidification process takes place between the set temperature-1 and 3oF above the set temperature. 4) Energy Saver: The unit runs the same as the COOL setting in the ENERGY SAVER mode. But the fan will be off 3 minutes after the compressor cycle off. 10 ON/OFF MODE SPEED TIMER TEMP/TIME Timer On or Timer Off mode is used to pre-start or shut off your unit in advance. You can use the Timer in 4 functions, i. e ENERGY SAVER, DEHUMID or FAN. Timer on (See Fig. #5) The unit must be on to set the timer. Unit will shut down automatically after it settings in 5 seconds. Use this mode to pre-set the start time of the unit 24 hou a) Press TIMER ON. LCD display will show "XX" (time set last time). When power i for the first time, LCD display will show "01". b) Set the desired number of hours by pressing the ( ) pad of the Temp/Time butt for each hour. If you passed the desired time, use the ( ) pad key to lower the c) After you set TIMER ON, LCD display will show the time. This time displayed me the unit will starts after X hours. #5) The unit must be running to set time off. Use this to preset the time you would l unit ot shut off. LCD display will show "XX" (time set last time). When power is for the first time, LCD display will show "01". b) Set desired number by pressing the ( ) pad of the Temp/Time buttons, once for hour. If you pass the desired time, use the ( ) pad key to lower the selection. [. . . ] Pull the tab slightly to release the filter. Pull the filter in the s as the opening. Clean the filter with warm, soapy water. The water should be below o o 40 C(104 F). [. . . ]