User manual HAIER GDZ5-1

[. . . ] Close supervision of children is necessary when the appliance is used near children. Before the appliance is removed from service or discarded, remove the door to the drying compartment. Do not reach into the appliance if the drum is moving. Do not install or store this appliance where it will be exposed to water and/or to the weather. [. . . ] Properly dried clothes will need minimum of care when removed from dryer. For optimum results, use dryer load of similar weight, fabric and construction. Place small items in a mesh bag to prevent from tangling. An average load will fill up half the drum. Select the drying temperature depending on the fabric type. Select the drying time depending on the fabric type and load size. Push the start button to start the drying cycle. Wait for the drying cycle to finish before opening the dryer door. Clean the lint filter after every load and before each use. A clean filter ensures sufficient drying. A layer of lint on the filter reduces airflow through the clothes and reduces drying time. · Avoid overloading, adding wet clothes to a partially dry load and over drying. · If you have multiple loads to dry, try to dry one load after another right away to take an advantage of a warm dryer. This way you already have a warm dryer and you save some time for drying. · Do not open door needlessly because it causes warm/hot air to escape; which prolongs drying time. · Use dryer during low humidity because it will be a normal drying time due to very less moisture in the air than during high humidity days where the air is very moist. CARE AND CLEANING GUIDE · Lint filter needs to be cleaned before and after each use for your unit to operate at optimum efficiency. The filter can be slid out, by pulling on the tab located on the inside of the dryer door. Remove the excess water from the filter by gently shaking the filter. This will remove dust and particles trapped in the filter. Lint build-up in screen restricts air flow, which causes longer drying times. After cleaning, slide the filter back in place. A time-delay fuse or circuit breaker is recommended. [. . . ] When the dryer stops, the dampers automatically close to prevent drafts and the entrance of insects and rodents. To avoid restricting the outlet, maintain a minimum of 12 inches (30. 5 cm) clearance between the vent hood and the ground or any other obstruction. The vent flap should be able to move freely. MAXIMUM EXHAUST LENGTH INSTALL MALE FITTINGS IN THE CORRECT DIRECTION 19 English After installation is completed, the following method must be used to determine if the exhaust system is acceptable: 1. [. . . ]