User manual HAIER GRL-26POT

[. . . ] NOTE: The gas service to the dryer must conform with local codes and ordinances and the latest edition of the National Fuel Gas Code, ANSI Z223. This dryer is not recommended for commercial application such as restaurants, beauty salons, etc. For your safety the information in this manual must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or loss of life. Combustible materials, gasoline, and other flammable vapors and liquids must not be stored near the dryer. [. . . ] DO NOT install your dryer in a closet with a solid door. A dryer installed in a bedroom, bathroom, alcove or closet MUST be exhausted outdoors. No other fuel burning appliance shall be installed in the same closet as the gas dryer. When installing the dryer in a closet with a door, a minimum of 120 square inches (774. 2 square cm) of ventilation in the door is required. Openings must be equally divided at the top and bottom of the door and airflow must be unobstructed. Dryer MUST be exhausted outside (outdoors, not beneath the manufactured home) using metal ducting that will not support combustion. If dryer is exhausted through the floor and area beneath the manufactured home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. When installing a gas dryer into a manufactured home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. This dryer MUST be fastened to the floor using P/N 0030807899 Manufactured Home Installation Kit. Approved strain relief into the power cord entry hole of the mounting bracket. Finger tighten the nut only at this time. Power cord, NEMA 10-30 Type SRDT, through the strain relief. Attach the power cord neutral (center wire) conductor to the brass colored center terminal on the terminal block. Reattach the strain relief mounting bracket to the back of the dryer with two screws. Tighten the screws securing the cord restraint firmly against the power cord. Remove the screws securing the terminal block access cover and the strain relief mounting bracket located on the back of the dryer upper corner. Install a UL approved strain relief into the power cord entry hole of the mounting bracket . Finger tighten the nut only at this time. Remove the green neutral ground wire from the green ground screw located above the terminal block. Children should not be allowed to use them to play with. [. . . ] All other costs such as the cost of the part. All other costs such as labor trip charge, etc are the responsibility of the owner. NOTE: This warranty commences on the date the item was purchased and the original purchase receipt must be presented to the authorized service representative before warranty repairs are rendered. exceptions: Commercial or Rental Use warranty. [. . . ]