User manual HAIER HBF05E

[. . . ] ® What The World Comes Home To TM Beer Dispenser BrewMaster Fontaine à Bière BrewMaster Dispenser De Cerveza BrewMaster Installation InstructionsModel # Instruction d'installationModèle # HBF05E Intrucciones De InstalacionModelo # English SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this operation manual. This appliance must be properly installed in accordance with the installation instructions before it is used. [. . . ] It is best to serve beer in a wet glass. Two Simple Tests for Clean Beer Glasses 1. Wash the glasses using your usual method. Immerse the glass heel first in clean water. If water droplets cling to the glass or if spots appear on the glass while pouring, the glass has not been cleaned properly. A clean glass should air-dry crystal clear. Again, wash the glass using your usual method. Pour out the water and then shake salt into the wet glass. If salt does not cling to the entire inside wall of the glass and clear unsalted spots remain, the glass is not clean. Converting the Beer Dispenser to an All-Refrigerator Application For your convenience, this beer dispenser can be converted to an all-refrigerator application. Simply follow the steps below for a quick and easy conversion. Note: When using as a refrigerator, we do not recommend the use of casters, as stored items may fall off the shelves when the unit is in motion. 13 Close the main valve on the CO2 cylinder. Close the connection between the beer keg and the keg coupler by pulling and lifting the handle of the keg coupler into an upright position. Disconnect both the beer line and the CO2 air line from the keg coupler. Remove the beer keg from the cabinet. English 5. Disconnect the air line from the CO2 cylinder. Remove the CO2 cylinder from the cabinet. Remove the beer tower from the cabinet by grasping the center of the tower. Pull the beer line through the top of the cabinet. Install the cabinet plug on the worktop. 10. We recommend that you place a piece of cardboard or cloth underneath the cabinet to avoid dents or scratches to the cabinet. Remove the casters and install leveling legs. Insert one end of each support pin into the holes on the right side of the cabinet. [. . . ] The mechanical and electrical parts, which serve as a functional, purpose of this appliance for a period of 12 months. This includes all parts except finish, and trim. The components of the sealed system e. g. hermetic compressor, condenser and evaporator from manufacturing defects for a period of 5 years from the date of purchase. [. . . ]