User manual HAIER HBF205E 04-06

[. . . ] Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1. Use this appliance only for its intended purpose as described in this operation manual. This appliance must be properly installed in accordance with the installation instructions before it is used. [. . . ] This is accomplished by the already installed two safety devices with adequate relief capacity in the system. Safety devices are installed in the following places: A. On or immediately downstream from the CO2 regulator. Follow the steps below to dispense beer. Open the beer faucet by pulling the tap towards you quickly and completely to dispense the beer. Note: If for any reason the beer does not come out of the tap, refer to the trouble-shooting guide on page 17. Increase the pressure if the beer runs too slowly. Proper foam should be a tight creamy head and the collar on an average glass should be 3/4" to 1" high. note: It is normal to see condensation forming on the outer surface of the faucet. It is caused by the difference in temperature between the cold beer and the inner surfaces of the faucet when beer is flowing through the line. To maintain this temperature in average room conditions of 70°F, set the thermostat to "Normal. " Note: During the summertime when temperatures are warmer, we recommend that you adjust the control to a cooler setting accordingly. Select and maintain the proper temperature inside the refrigerator cabinet. This is necessary for maintaining the flavor freshness of beer. Excessively cold or warm temperatures inside the refrigerator cabinet may cause a loss of flavor. The temperature control is located at the rear of the unit on the bottom left-hand corner. After turning the unit on, you must wait 24 hours for the unit to cool properly. You may then adjust the temperature setting based on your needs and preferences. Ice that has deposited on the evaporator is automatically defrosted when the compressor cycles off. Bubbling or gurgling sounds and slight vibrations are the result of the refrigerant circulating through the cooling coils. Sizzling or popping sounds occur during the automatic defrost cycle. Dripping sounds occur as ice melts from the evaporator and flows into the water collection tray during the automatic defrost cycle. [. . . ] Cause 1 Where air is used as a pressure source, air replaces the CO2 in beer, causing flat beer. This problem is not evident when beer is being drawn rapidly. correction · Whenever possible, use CO2 Gas as a pressure source. In-Home Service What is covered and for how long? [. . . ]