User manual HAIER HDG 5300 AW

[. . . ] Actual model may vary per model purchased. Before beginning installation, carefully read these instructions. this will simplify the installation and ensure the dryer is installed correctly and safely. NOTE: The electrical service to the dryer must conform with local codes and ordinances and the latest edition of the National Electrical Code, ANSI/ NFPA 70 or in Canada, CSA C22. [. . . ] For your convenience, there are 6 fabric care dry cycles programmed in this mode: Bulk Items, Heavy, White, Normal, Delicate, Press Free. Heavy weight material such as jeans or bath towels. Use to select normal clothes worn in daily use. Drying small quantity clothes and delicate fabric. Used to set drying level of auto-programs. If manual dry is selected, touching the pad will cause two beeps to sound. there are 5 selections: Very , More , Normal , Less , Damp. First select sensor dry cycle then adjust the dry level to how much you want to dry the load. Note: Dry level selection can only be made while using the Auto (Sensor) Dry Cycles. For Auto Dry Cycles the temperature can be selected only for settings below the default setting, Air Dry cannot be selected. This controls the volume of beep when you touch any pads on the control panel or when the dry cycle is completed. This function can be selected only in certain cycles. Here the heat temp is raised to the highest dry level. This option can only be used with heavy, bulky items, White and Normal cycle. This convenient feature helps keep wrinkles from setting when you cannot unload the dryer at the end of a cycle. The dryer will stop and then rotate for a brief period every few minutes. press the wrinkle saver pad to activate. This feature will work for 1 hour after the drying program is completed. Stop the setting at any time by pressing the wrinkle pad or by opening the dryer door. more Time & Less Time Pad: (10) · Used to set time from 0 to 2 hours when Timed Dry, Rack Dry, Speed Dry or Touch Up cycles selected. damp Dry Signal (11) · If activated the dryer will beep when the load is approximately 80% dry. This will allow you to remove lightweight items that are dry or other items that you 21 This allows you to save a favorite cycle, set the desired settings and touch "Custom Program"pad for 3 seconds. [. . . ] For the name and telephone number of the nearest authorized service center please call 1-877-337-3639. Before calling please have available the following information: Model number and serial number of your appliance( found on the rear of the unit on the upper left hand side). The name and address of the dealer you purchased the unit from and the date of purchase. This warranty covers appliances within the continental united States. [. . . ]