User manual HAIER HHX6030 05-05

[. . . ] Range Hood Extractor de Aire Hotte de Cuisiniere User Manual Model HHX6030 Guide de l'Utilisateur HHX6030 Manual del Usuario Modelo HHX6030 Quality n Innovation n Style English SAFETY PRECAUTIONS Warning!­ To reduce the risk of fire, electric shock, or injury to persons, always exercise basic safety precautions, including the following: 1. Read all instructions before using the appliance. Use this appliance only for its intended purpose as described in this user manual. [. . . ] Use a 3/8" nut driver or ratchet to remove the 4 nuts holding it in position (Fig. Place the blower and nuts somewhere safe until needed. The wires to the blower are inside a housing. The top of the housing must be removed first to get to the blower wires. Turn the hood right side up so you can see the duct knockouts and mounting holes. 1 5 English Cabinet Preparation for Hood Support Mount the hood so that the bottom of the hood is between 24"-30" above the stovetop. When cutting or drilling into wall or cabinet, be careful not to cut existing electrical wiring. If the bottom of the cabinet is recessed above the bottom of the cabinet door, then it is necessary to install wood strips on each side of the recessed area on the bottom of the cabinet where the range hood will be mounted. The wood strips should line up with the 4 keyhole slots on the top of the range hood. Fasten the wood strips with wood screws about 3" in from each end. Note: The thickness of the wood strips should be slightly more than the recessed dimension. Measure and mark the electrical wiring opening in the wall or the cabinet. If the hood is to be vented, also mark and measure the duct opening in the wall or cabinet. Selecting the Venting Direction The range hood can be used for either horizontal, vertical or ductless air discharge. Your range hood is supplied with a 3-1/4" x 10" damper frame for a transition piece from the hood to the ducting. Below is a brief ducting installation description. Your installation will depend on whether there is an existing ducting or whether you need to install a ducting run. For the best performance, use the shortest possible ducting path and the least amount of elbows when discharging horizontally or vertically. Vertical Discharge ­ Vertical discharge is the most common method of hood installation. If your kitchen has an attic space above, the ducting may be run through the cupboard and the attic to A a roof cap. Another option, if your kitchen has a soffit above the cabinet, is to run the duct up into the soffit and B then discharge the air horizontally through the outside wall to a wall cap. Horizontal Discharge - If the range is located against an outside wall, then horizontal discharging is ideal, provided there are no obstructions such as wall joists or places where openings are difficult to make. A If a wall cap is used directly off the back of the hood, special care must be taken to ensure that the damper in the B damper/duct connector on the hood and the damper in the wall cap do not interfere with each other when the range hood is operating. This could result in either inadequate air delivery or back drafts. [. . . ] If you do not see a duct, your unit may be venting through the back wall. Light does not turn on (but fan turns on). This could be because the bulb has burned out. If the light still does not work, either the light switch or the lamp-holder socket is defective. Both can be replaced without removing the range hood from the wall or cabinet. Night light does not turn on. [. . . ]