User manual HAIER HI1MK

[. . . ] a) 1/4 inch copper supply line with shut off valve. b) 1/4 inch brass compression nut and ferrule (sleeve). · The copper tubing and shut off valve should be available at your local hardware or plumbing supply store. Coil enough tubing in the back of the unit to allow movement for cleaning. Tools Required for Installation Plastic putty knife Phillips screwdriver 1/4-inch socket wrench or nut driver Adjustable wrench Needle nose pliers Power drill with Phillips bit #2 1 English Parts Included 1. [. . . ] (See fig # 9) (Figure 9) 6 English 4. Insert the other end of the plastic water tubing into the bottom of the water valve. Tighten the plastic nut, while pushing the tube inside the valve. (See fig # 10) Water Valve (10) (Figure 10) Plastic Nut Plastic Water Tubing (3) To Icemaker Fill Tube 5. Using a power drill with a Phillips-head bit, drive in the 2 supplied self tapping screws to attach the water valve to the right side of the refrigerator. # 11) Water Valve (10) (Figure 11) Factory Punched Holes Screws (4) 7 English Water Supply Connection WARNING This water supply installation is not warranted by the refrigerator or icemaker manufacturer. Follow these instructions carefully to minimize the risk of expensive water damage. Supplies Required for Installation: · Access to a household cold water line with water pressure between 20psi. · A water supply line made of 1/4-inch OD, copper tubing. To determine the length of the copper tubing needed, you will need to measure the distance from the ice maker inlet valve at the back of the refrigerator to your cold water pipe. Then add approximately 7 feet, so the refrigerator can be moved out for service. · A shutoff valve to connect the water supply line to your household water system. Note: Do Not use a self-piercing type shutoff valve. · A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve. 1. Turn off the water supply at the shut off valve. Remove the plastic cap from the water valve inlet. Insert the brass compression nut and the ferrule (sleeve) onto the end of the copper water line as shown in the picture. 8 English 4. Now push the water supply line into the water valve inlet as far as it will go. Slide the ferrule (sleeve) into the valve inlet and finger tighten the compression nut onto valve. Tighten another half-turn with a wrench. Now, screw rear access panel that covers compressor compartment back in place. # 12) Plastic Water Tubing to Ice Maker Fill Tube Steel Clamp Brass Compression Nut Ferrule (Sleeve) Copper Water Line Water Valve Bracket Valve Inlet Water Valve (Figure 12) Copper Water Line from Household Water Supply (Include enough tubing in loop to allow moving refrigerator out for cleaning. ) Power cord Plastic water tubing Coper water line 5. With the supplied steel clamp and hex head screw, secure the water supply line to the rear panel of the refrigerator. 9 English 6. [. . . ] WARRANTOR IS NOT RESPONSIBLE FOR CONSEQUENTIAL DAMAGES. THIS LIMITED WARRANTY IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. The remedy provided in this warranty is exclusive and is granted in lieu of all other remedies. This warranty does not cover incidental or consequential damages, so the above limitations may not apply to you. [. . . ]