User manual HAIER HLP21N

[. . . ] This includes the foam and any adhesive tape both inside and outside of the unit. Inspect and remove any remains of packing, tape or printed materials before powering on the Washer. Before throwing away your old appliance, remove the door so that children may not easily become trapped inside. Thank you for purchasing our Haier product. [. . . ] Your washer has 4 adjustable levelfing legs that fis located on the front rfight corner. After properly placing your washer in its final location, you must level the washer. An "off-balance" washer will not function properly and can stop. The leveling leg can be adjusted by turning the center foot counter-clockwise to raise the foot and clockwise to lower the washer. Once the foot is at the right height, then lock that positi on us i ng the outer and larger ri ng of the fi xed foot. Note: If the washer is inclined more than 2°, the machine will not operate. This washer can convert from fixed feet to casters for mobility and portability. The best time to change from fixed feet to casters is when installing the bottom panel. Screw each of the 4 casters to the bottom base by hand first, then use a wrench to secure the caster's locking bolt to the washer body. Read the installation instructions carefully and ensure washer location before beginning. When installing the quick sink faucet adapter to the faucet, follow the steps below: 1. First, remove the aerator from your faucet nozzle and determine the size/type of the faucet. Once you determine the size/type of the faucet (Outside Threaded End or Inside Threaded End), place the proper sized rubber washer into the silver faucet adapter. Attach the other end of the water inlet hose to the washer water inlet and make sure that the rubber washer is placed in between. As a second option, you can install directly to a fixed utility hot and cold water outlet by using a "Y Hose" (NOT supplied) . The drain hose must be placed into a drainpipe or sink at least 1-1/2 inches in diameter. use the gooseneck drain hook to hold the hose in place. To avoid possible water back-up, the drain hose must reach a height of at least 31-1/2 inches minimum and 40 inches maximum. Laundry tub: Just hang hook over side of sink or for a more permanent use plastic ties. Plug fin the washer to a regular 120 Volt / 60 Hz, 15 Amps outlet, only after all water and drain lines are connected . Note: Carefully inspect for any leaks around the machine and at the back. If there is a leak, check if any connections are loose. [. . . ] Second through Seventh Year Haier will provide the inner stainless steel wash tub if defective in material or workmanship. Note: This warranty commences on the date the item was purchased and the original purchase receipt must be presented to the authorized service representative before warranty repairs are rendered. Exceptions: Commercial or Rental Use Warranty 90 days labor from date of original purchase 90 days parts from date of original purchase No other warranty applies For Warranty Service Contact your nearest authorized service center. all service must be performed by a Haier authorized service center. [. . . ]