User manual HAIER HPIM25S

[. . . ] When using electrical appliances, basic safety precautions should always be followed, including the following: 1. To protect against risk of electric shock, do not immerse cord, plug or any parts of the unit in water or other liquids. Close supervision is necessary when using this appliance near children. This appliance is not suitable for use by children. [. . . ] Open the top cover, take out the ice storage basket and fill the water reservoir with drinkable (tap, purified or bottled) 2. 3 quarts water to the level mark and replace the ice storage basket. Make sure that the water level does not reach above the level mark or the bottom of the ice storage basket. Note: During the operation process, if the level of water in the water reservoir becomes too low, the machine will automatically stop operating and the "Add Water" indicator will display on the LED. Push the ON / OFF button on the control panel to turn on the machine. Select the desired size of ice cube by pressing the S or L ice selector button. 12 minutes) The icemaker will start making ice soon after. The next cycle of 9 ice cubes is complete (based on water temperature, ambient room temperature and selected ice cube size). Water is pumped from the water storage tank to the water box, which may take up to 1 minute. The icemaking cycle begins when the evaporator rods are dipped into the water box. It will take approximately 5-13 minutes for each icemaking cycle, depending on the size selected. The larger the size, the more time is needed to make the ice. After the cycle is finished, the water box will tilt forward and the remaining water will flow back into the water storage tank. The evaporator rods will then release the ice cubes. Note: If the room ambient temperature is below 60° F, then small ice cube sizes are suggested to prevent ice cubes from fusing together. Approximately 60 seconds later, the water box will tilt backwards and the ice pusher will push the ice into the ice storage basket. After the water box flips back to its original position, the next icemaking cycle will begin. When the maximum capacity of ice cubes is collected and the ice reaches the temperature sensor, the icemaker will automatically stop operating. the "ICE FULL" LED indicator will light up. If more ice is needed, remove the ice from the ice storage basket; then replace the basket into the machine, making sure that the basket is placed back to its original position. To continue making ice, check that there is water in the water storage tank. If there is no water in the water storage tank, then no water will be pumped into the water box, and the operation will stop. [. . . ] Remove ice from the ice storage basket to make more. Plug the unit into a standard 110/120 Volt, 60 Hertz power source. Please run the icemaker in temperatures below 90°F and/or pour colder water into the water reservoir. Start the machine after the ice block melts. [. . . ]