User manual HAIER HPM09XC5 11-04

[. . . ] Dealer's Name:. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dealer's Address: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Dealer's Phone Number: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TABLE RECEPTACLE RATED VOLTS AMPS 125/60 15 AND 20 FUSE TYPES 15 250/60 20 30 WALL OUTLET FUSE SIZE TIME DELAY FUSE (or circuit braker) 15 Plug 20*15 Plug 20* Plugm 30 1 English SAFETY PRECAUTIONS WARNING: Following these basic precautions will reduce the risk of fire, electrical shock, injury or death when using your air conditioner. 1) Air conditioner must be connected to proper electrical outlet with the correct electrical supply. (see table previous page) Proper grounding must be ensured to reduce the risk of shock and fire. [. . . ] Line up the holes and tighten the Adapter with 4 screws that are included in the kit. Install the Window Plastic Panel into the window. If necessary use duct tape to better secure the panel. Connect exhaust hose to the unit by inserting the hose connector that is attached to the hose into the exhaust. Move the unit to the window, extend the hose and attach the other end of the hose to the window. Align the tabs on the hose and window panel adapters and fasten them together. A B Hose Connector Exhuast Hose Hose Connector 6 English Operation NOTE: Wait for 24 hours to turn on air conditioner if the unit has been tilted for any reason. This is for the oils and the coolants to settle and level off. After a normal shut down wait for 3 minutes before restarting the unit so as to complete the compressor cycle. Use an 115v /15 amp outlet for the air conditioner. Do not use any other electrical appliances on this line or you may trip the fuse. Use a dedicated line for this air conditioner. Do not place the air conditioner in direct sunlight or close to any heating appliances (eg. Keep the unit free of any obstructions such as drapes, curtains, blinds, etc. Keep unit at least 1 foot away from the wall. Check and clean the filter once every week for highest efficiency. If the unit is not being used for a long period of time, remove the plug from the water drain pipe and drain out any condensed water. CONTROL PANEL OPERATIONS 1. Timer Control - Timer Settings 1-8 Hours If you turn the dial to CONT this will override the timing control and the unit turned to the Off position. By turning the dial to one of these numbers the unit will turn off automatically when the dial to one of these numbers the unit will turn off automatically when the dial returns to the position. Fan Speed Control - Fan/Cooling This dial operates in FAN ONLY or COOLING modes to set fan speed. Cooling Control - Turn clockwise to CONT for maximum cooling position This dial sets the desired cooling temperature and will turn the compressor off automatically once the desired temperature is reached, the fan will continue running. When the room temperature rises the compressor will come on and resume the cooling operation. If you turn the dial fully clockwise to CONT this is maximum cooling position. [. . . ] · Unit may be in fan or dry mode. Put air conditioner in cool mode. 9 English Limited Warranty This warranty covers all defects in workmanship or materials for: 1. The mechanical and electrical parts (including labor costs) contained in this Haier product, for a period of 12 months, from the date of purchase, (commercial or rental application, the warranty is 90 days). The sealed system and compressor contained in this Haier product is for a period of 5 years, from the date of purchase (excluding labor costs after the initial 12 month period). [. . . ]