User manual HAIER HR-1770M

[. . . ] Microwave Oven Instruction for use HR-1770M HR-1770MG Specific No. 0050502346 Electricity schematic diagram HR-1770M FUSE Timer switch1 Timer switch2 The Primary interlock switch HVC F AK-Rectifier FA Magnetron Monitoring switch Curbing motor Timer motor Fan motor Lamp L N E M MF MT HVD HVT Thermostat The Second interlock switch Attention: The figure indicates the circuit diagram that the door is open and the microwave oven is not working. HR-1770MG FUSE The Primary Timer Timer interlock switch1 switch2 switch Timer GR switch HVC AK-Rectifier L (IN) Curbing motor Thermostat Grill heater F FA Magnetron Monitoring switch Timer motor Fan motor Lamp L N E M MF HVD MT HVT N (IN) Thermostat The Second interlock switch Attention: The figure indicates the circuit diagram that the door is open and the microwave oven is not working. Spacer Rod (a) (b) Spacer Rods Cavity Holes Fix spacer rod here (c) Enlarged view Warning! 1. For your use safety, before installing this model of microwave oven, please take out the locating spacer rods from the cavity (as illustrated in Figure 1 of the left), and insert them respectively into the two locating holes at lower part of the cavity rear panel as illustrated, so as to ensure good ventilation between the microwave oven and back wall. No one except the professional technicians can decompose the microwave oven. [. . . ] d) Clean the oven interior with a damp cloth. Do not use sharp cleansers or scouring agents!e) Unpack the turntable (not all models are equipped with) and its undercarriage 10 3 English Instruction for use English Instruction for use f) Place the undercarriage in the circular track on the oven interior floor. g) Lay the turntable onto the undercarriage. By gently turning it, the guide fits into the drive shaft. Place the appliance on an even and non-skid surface. It must be stable enough to easily support the appliance even if the oven contains goods. Leave a space of at least 10 cm between the foremost edge of the worktop and the front of the oven door . You will thus prevent the appliance from tilting forward when the door is open. Install the oven in a place where it is protected against splashing water or dripping liquids. Sunlight and humidity may impair operational safety. Never expose your microwave oven to direct sunlight (overheating hazard). Do not install the appliance in the immediate vicinity of heat sources such as radiators or cookers. The following minimum clearances between other objects / walls must be maintained for safety purposes: - Side l/r clearance at least 5 cm - Rear clearance at least 10 cm - Upper clearance at least 30 cm The appliance must not be built into a cupboard. The oven must not be built in underneath a panel or a cupboard. For some models a built under - mounting set is commercially available. Please ask your dealer or the respective customer support service. It can thus also be operated easily even if the interior lamp has failed. Steam escaping from the air vent is quite normal during operation. This is not a malfunction. 10 Calling the Customer Support Service To ensure prompt help when needed, please have ready the following data before calling the customer support service: Appliance Type / Model (see rating plate) Date of purchase Name and location of your dealer Description of the malfunction The address and phone number of the customer support service center responsible for your appliance can be found in the attached customer support service directory , or in the guarantee card. 11 Guarantee Please note the general guarantee terms and the guarantee period stated in the attached guarantee card. If the appliance documentation does not include a guarantee card, please contact your dealer. The manufacturer works constantly at the further development of all products. [. . . ] Therefore, leave the door open and only close it when you have correctly entered all settings. If you wish to set the cooking time to less than the max. and then back to the desired cooking time. In most models a warning beeper will sound when the timer has elapsed. [. . . ]