User manual HAIER HRF12WND

[. . . ] Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1) Use this appliance only for its intended purpose as described in this use and care guide. 2) This refrigerator must be properly installed in accordance with the installation instructions before it is used. see grounding instructions in the installation section. [. . . ] Remove the door stoppers from the freezer and refrigerator doors and install them on the opposite side of the door. Remove the lower pivot pin from the bracket of the lower hinge by turning counter clockwise. Loosen the screws holding the lower hinge bracket and remove the hinge. Bottom hinge pad lower bracket lower pivot pin lower pivot pin hole fig. To install refrigerator door: make the left bottom hole of the refrigerator compartment door fall over the lower hinge axle, move door forward to make it straight and in alignment with central hinge. Install the central hinge again, turn the hinge axle until it completely enters the door body, then fix it with screws. To install freezer door: make the left bottom hole of freezer door fall over the central hinge axle; raise upper hinge, so that hinge axle can be installed in the upper hole of the upper part of the freezer door; adjust door to make it straight and level. Your refrigerator will automatically maintain the temperature level you select. Turning the dial to OFF stops cooling in both the refrigeration and freezer sections. At first, set the dial to 4 and allow 24 hours to pass before adjusting the temperature to your needs. To adjust the temperature range in the cold setting, turn the temperature dial in a clockwise direction. For normal operating conditions, keep the dial halfway between cold and coldest. For your convenience, the factory presets the control at normal operating conditions. (Note: If the refrigerator has been placed in a horizontal or tilted position for any period of time wait 24 hours before plugging the unit in. Your refrigerator is equipped with an automatic interior light in the fresh food section for you to easily locate your food. Your freezer compartment is equipped with adjustable airflow control. For your convenience, airflow is preset by the factory to the normal setting. There is also an option to adjust the settings, either to low freezer or to high freeze. Your refrigerator may be equipped with slide control to raise or lower the humidity levels or your crispers. This feature will increase the storage life of your fruits and vegetables. Simply adjust the controls to the appropriate setting for setting for items you are storing in the crispers. Low settings allow moist air to exit the crisper, for optimum storage of fruit and/or vegetables that have skins. [. . . ] Note: Do not move the refrigerator sideways as this may cause damage to the floor covering of your refrigerator. When cleaning has been completed, plug the cord back into the outlet and slide the refrigerator straight back to its original position. Note: When pushing it back, be sure not to roll over the power cord. Allow light bulb to cool before removing. [. . . ]