User manual HAIER HS-06CA04

[. . . ] Unit start Press ON/OFF on the remote controller, unit starts. 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Remote controller: AUTO COOL DRY FAN 3 3 Then Select COOL operation 3. Select temp. setting Press TEMP. button Every time the button is pressed, temp. setting increase 1oC, if kept depressed, it will increase rapidly Every time the button is pressed, temp. setting increase 1oC, if kept depressed, it will decrease rapidly Select a desired temperature. 2 4 4. Fan speed selection Press FAN button. [. . . ] For each press, fan speed changes as follows: Remote controller: AUTO HI LOW 1 5 When FAN is set to AUTO, the air conditioner automatically adjusts the fan speed according to room temperature. 5. Unit stop Press ON/OFF button, the unit stops. Cautions To protect unit system, don`t restart until 3 minutes have elapsed If the unit has been running under large humidity for a long time, dew might occur at outlet grating 6 Air Conditioner Edition:2006/02/07 Auto mode 1. Unit start Press ON/OFF on the remote controller, unit starts. Remote Controller 2. Select operation mode Press MODE button. For each press, operation mode changes as follows: Remote controller: AUTO COOL DRY FAN 3 Then Select Auto operation 3 3. Select temp. setting Press TEMP. button Every time the button is pressed, temp. setting increase 1 C, if kept depressed, it will increase rapidly Every time the button is pressed, temp. setting increase 1 C, if kept depressed, it will decrease rapidly Select a desired temperature. 2 4 4. Fan speed selection Press FAN button. For each press, fan speed changes as follows: Remote controller: AUTO HI LOW 1 5 Air conditioner is running under displayed fan speed. When FAN is set to AUTO, the air conditioner automatically adjusts the fan speed according to room temperature. 5. Unit stop Press ON/OFF button, the unit stops. About Auto Operation Under the mode of auto operation, air conditioner will automatically select Cool or Heat operation according to room temperature. Cautions In Auto mode, the unit will select operation mode automatically according to room temp. Auto mode:Air conditioner automatically changes between COOL and DRY and from mode. is over 26 C, in COOL mode; when room temp. For each press, operation mode changes as follows: Remote controller: AUTO COOL DRY FAN Then Select FAN operation 2 3. Fan speed selection Press FAN button. For each press, fan speed changes as follows: Remote controller: HI LOW 3 Select desired fan speed. Change air flow if necessary 1 4 4. Unit stop Press ON/OFF button, the unit stops. Hints In FAN operation mode, the unit will not operate in COOL mode but only in FAN mode , AUTO is not available in FAN mode. And temp. setting is disabled. In FAN mode, SLEEP operation is not available. 10 Air Conditioner Edition:2006/02/07 Sleep operation 1. Start unit and confirm its operation mode Remote Controller 2. Select SLEEP function Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: Remote controller: SLEEP TIMER OFF TIMER ON BLANK Select "SLEEP" function 2 Hints Before going to bed, you can simply press the SLEEP button and unit will operate in SLEEP mode and bring you a sound sleep. Use of SLEEP function After the unit starts, set the operation status, then press SLEEP button before which the clock must be adjusted and time being set. In COOL, DRY mode 1 hours after SLEEP mode starts, temp. [. . . ] Use of SLEEP function After the unit starts, set the operation status, then press SLEEP button before which the clock must be adjusted and time being set. In COOL, DRY mode 1 hours after SLEEP mode starts, temp. The unit will run for further 6 hours then stops. [. . . ]