User manual HAIER HSU-12C03-K

[. . . ] Installation Manual of Room Air Conditioner Read this manual before installation Explain sufficiently the operating means to the user according to this manual. Necessary Tools for Installation 1. Driver 2. Hacksaw 3. Hole core drill 4. Spanner(17, 19 and 26mm) 5. Torque wrench(17mm, 22mm, 26mm) 6. Pipe cutter 7. Flaring tool 8. Knife 9. Nipper 10. Gas leakage detector or soap-and-water solution 11. Measuring tape 12. Reamer Drawing for the installation of indoor and outdoor units Accessory parts No. 1 2 3 Mounting plate more than 5cm Accessory parts Remote controller Number of articles 1 2 1 1 6 4 1 4 1 1 Optional parts for piping Mark A B C D E F G Parts name Non-adhesive tape Adhesive tape Saddle(L. S) with screws Connecting electric cable for indoor and outdoor Drain hose Heating insulating material Piping hole cover mo re t han 10c m R-03 dry battery mo re t han 10c m 4 5 6 7 8 9 10 Drain hose 4X50 Steel nail, cement 4X25 Screw Plastic cap Cover Cushion Attention must be paid to the rising up of drain hose A C Arrangement of piping directions mo re t Rear left Left Rear right Below Right ha n1 0c m re t mo han 10c m Pipe supporting plate Drain-elbow D E more than 60cm mor e th an 1 5cm The marks from A to G in the figure are the parts numbers. [. . . ] Pull out the cable on the front side, and connect the cable making a loop. When connecting the cable before installing the indoor unit Insert the cable from the back side of the unit, then pull it out on the front side. Loosen the screws and insert the cable ends fully into terminal block, then tighten the screws. Pull the cable slightly to make sure the cables have been properly inserted and tightened. After the cable connection, never fail to fasten the connected cable with the wiring cover. Note: When connecting the cable, confirm the terminal number of indoor and outdoor units carefully. If wiring is not correct, proper operation can not be carried out and will cause defect. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. The type of connecting wire is H05/07RN-F or 245IEC57(YZW). If the fuse on PC board is broken please change it with the type of T. If the fuse of outdoor unit on PC board is broken, please change it with the type of T. The wiring method should be in line with the local wiring standard. After installation, the power plug should be easily reached. [. . . ] Charge according to the following list. for Piping length Additional amount 5m No need 09k 12k 7m 40g 10m 100g Indoor unit Outdoor unit A Outdoor unit A B Indoor unit B Outdoor unit A C Oil trap Indoor unit B Max. Elevation:B=5m Max. Length: for 9k A=7m for 12k A=10m 4 CAUTION In case more than 5 metresoil trap should be installed every 5~7m. C [. . . ]