User manual HAIER HSU-18HB03

[. . . ] It must be noticed that air conditioner system contains refrigerants, which require specialized waste disposal. The valuable materials contained in an air conditioner can be recycled. Contact your local waste disposal center for proper disposal of an old air conditioner and contact your local authority or your dealer if you have any question. Please ensure that the pipework of your air conditioner does not get damagedprior to being picked up by the relevant waste disposal center, and contribute to environmental awareness by insisting on an appropriate, anti-pollution method of disposal. [. . . ] If the unit which you purchased has not health function, remote controller should like the following figure: 1. Mode display AUTO COOL DRY HEAT FAN LOW MED HI AUTO 2. MODE Used to select AUTO, COOL and FAN 11. TIMER Used to select TIMER ON, TIMER OFF 13. RESET Used to reset the controller back to normal condition. CODE Used to select code A or B with a press, A or B will be displayed on LCD. please select A without special explanation 15. TEMP Used to select your desired temperature 22. POWER ON/OFF Used for unit start or stop 24. SET Used to confirm timer and clock settings 26. HOUR Used to set clock and timer settings 27. LOCK Used to lock buttons and LCD display. NOTE:(1)The following functions and related displays are not available: AUXILIARY HEAT display, POWER/SOFT display, HEALTH display. (2)If the Air conditioner don't have the function of the code , press code B can cause it not available. (3)Cooling only unit do not have functions and displays related with heating. Clock set When unit is started for the first time and after replacing batteries in remote controller, clock should be adjusted as follows: Press CLOCK button, "AM" or "PM" flashes. It is harmful to your health in summer to go frequently in and out of places where temp. difference of 3-5 C will remove your fatigue. More than this, unit's load can be reduced and power consumption cut down as well. difference of 3-5 C between indoor and outdoor temp. in COOL mode. 11 Operation TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)TIMET mode selection Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: ON TIMER ON OFF TIMER OFF ON OFF blank TIMER ON-OFF Select your desired TIMER mode (TIMER ON or TIMER OFF) ON or OFF will flash. (3)Timer setting Press HOUR / button. Every time the button is pressed, time increases 10 min. If button is kept depressed, time will change quickly. Every time the button is pressed, time decreases 10 min. If button is kept depressed, time will change quickly. [. . . ] In FAN mode, comfortable sleep is not available. SLEEP mode starts SLEEP mode stops Fig. 2 16 Maintenance Different models have different appearance Cleaning of unit casing Cut off power supply before cleaning unit casing with soft cloth. In case of heavy stain, clean it with neutral detergent. squeeze water in the cloth, wipe off the detergent on unit casing completely. Cleaning of remote controller Cleaning of air filter Don't use water to wash unit casing, please use dry cloth. Don't use glass cleaner or cloth soaked with chemicals. Air Filter 1. Open inlet grille by pulling it upward. 3. Clean the filter Use a vacuum cleaner to remove dust, or wash the filter with water. [. . . ]