User manual HAIER HSU-22CD03/R1

[. . . ] If the fuse on PC board is broken please change it with the type of T. The distance between the indoor unit and the floor should be more than 2m. The wiring method should be in line with the local wiring standard. After installation, the power plug should be easily reached. [. . . ] Previous operation status appears on display. (Not Timer setting) Power indicator on indoor unit lights up. Enjoy yourself by just a gentle press. (2) Select operation mode Press MODE button. For each press, operation mode changes as follows: ON/OFF TEMP 1 4MODE SET AUTO COOL DRY HEAT FAN 2 FAN TIMER Unit will run in selected mode. Stop display at " " AUTO or " 3 "FAN. SWING CLOCK (3) FAN Press FAN button. For each press, fan speed changes as follows: SLEEP LOCK RESET AUTO LO MED HI (4) Unit stop Unit will run at selected fan speed. Vertical flap closed automatically. Hints Remote controller can memorize settings in each operation mode. To run it next time just select the operation mode and it will start with the previous setting. No reelecting is needed. (TIMER ON/OFF needs reelecting) Cautions: Note: On cooling only unit, heating mode is not available, The above information is the After replacing batteries, press ON/OFF, and display explanation of the displayed becomes as follows: information therefore varies Operation mode: AUTO, Temp. No with those displayed in actual Timer mode: No, Fan speed :AUTO operation. 6 Operation COOL, HEAT and DRY operation Recommendations: (1) Unit start Press ON/OFF button, unit starts. Previous operation status appears on display. (Not Timer setting) Power indicator on indoor unit lights up. Use COOL in summer. Use HEAT in winter Use DRY in spring, autumn and in damp climate. (2) Select operation mode Press MODE button. difference of 3-5 C between indoor and outdoor temp. in COOL mode. 8 Operation TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)TIMET mode selection Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: ON TIMER ON OFF TIMER OFF ON OFF blank ON/OFF TEMP TIMER ON-OFF 1 MODE SET Select your desired TIMER mode (TIMER ON or TIMER OFF) ON or OFF will flash. 3 FAN 4 TIMER (3)Timer setting Press HOUR / button. Every time the button is pressed, time increases 10 min. If button is kept depressed, time will change quickly. Every time the button is pressed, time decreases 10 min. If button is kept depressed, time will change quickly. It can be adjusted within 24 hours. 3 SWING 2 CLOCK SLEEP LOCK RESET (4)Confirming your setting After setting correct time, press SET button to confirm, "ON" or "OFF" stops flashing Time displayed: Unit starts or stops at x hour x min. Timer mode indicator on indoor unit lights up. To cancel TIMER mode Just press TIMER button several times until TIMER mode disappears. Hints After replacing batteries or a power failure happens, Time setting should be reset. [. . . ] After washing, dry the filter completely in the shade. 2. Remove air filter Push up the filter's center tab slightly until it is caesura of the stopper. Remove it by pulling down. 5. Close the inlet grille. 4. Attach the filter Attach filter behind the stopper so that the "Front" indication is facing to the front. Make sure that it is completely behind the stopper, otherwise problems might occur. 13 Maintenance Replacement of Air purifying Filter Open the Inlet grille Open the Inlet grille by pushing each ends of the Inlet grille upward. (use thumbs to push up) Detach the standard air grille Slide the knob slightly upward to release the filter, then withdraw it. Air Filter Attach new Air Purifying Filter Put air purifying filter appliance into the left and right . Detach the Air Purifying Filter Air Purifying Filter Air Purifying Filter Note: the green aspect of the bacteria-killing medium air purifying filter will face outside; the white aspect will face to the machine. Install air purifying filter (Necessary installment) Close the Inlet grille Close the grille surely. NOTE: The photocatalyst air purifying filter and the bacteria-killing medium air purifying filter will be used based on real situation. [. . . ]