User manual HAIER HTE08WNA 07-01

[. . . ] hte10wna/hte08wna manual 10/22/01 11:49 AM Page 1 Two Door Auto Defrost Refrigerator Le Manuel de Deux Portes Dégivrent le Réfrigérateur El Manual de Dos Puertas Descongela el Refrigeradore User Manual(Features May Vary per Model) Model # Guide de l'Utilisateur- Modèle (Les caractéristiques Peuvent Varier par le Modèle) HTE10WNA HTE08WNA Manual del Usuario(Las características Pueden Variar por el Modelo) Para Modelo de hte10wna/hte08wna manual 10/22/01 11:49 AM Page 2 English SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safety precautions, including the following: 1) Use this appliance only for its intended purpose as described in this use and care guide. 2) This refrigerator must be properly installed in accordance with the installation instructions before it is used. See grounding instructions in the installation section. [. . . ] You can select your preference of door opening by following the procedure to make the change. Dismantling: (see fig. Fix refrigerator and freezer door by sticking adhesive tape on both sides to hold doors in place. 1, dismantle the hinge box cover on the upper part of freezer door with a phillips head screwdriver. Then remove the three screws from the hinge. Take out the hinge by pulling it vertically, and keep it in a safe place. Remove the adhesive tape on freezer door, lift and take the door down, and carefully put it aside. Dismantle two screws of the central hinge, lift and take down the central hinge, and keep them in a safe place. Remove the adhesive tape on refrigerator door, lift and take down refrigerator door, and carefully put it aside. Remove the door stoppers from the freezer and refrigerator doors and install them on the opposite side of the door. (Not on all Models) screw holes stop of freezer door (Not on all Models) fig. # 3 middle pivot pin middle bracket (central hinge bracket) stop of refrigerator door (Not on all Models) 8 hte10wna/hte08wna manual 10/22/01 11:49 AM Page 10 English Reinstallation: (see fig. Remove the lower pivot pin from the bracket of the lower hinge by turning counter clockwise. Move the pin to the opposite hole and tighten. Loosen the screws holding the lower hinge bracket and remove the hinge. bottom hinge pad lower bracket lower pivot pin lower pivot pin hole 3. Align the holes in the lower hinge bracket to the corresponding holes in the opposite side of the cabinet. To install refrigerator door: make the left bottom hole of the refrigerator compartment door fall over the lower hinge axle, move door forward to make it straight and in alignment with central hinge. Install the central hinge again, turn the hinge axle until it completely enters the door body, then fix it with screws. fig. # 4 stop of freezer door (Not on all Models) middle pivot pin screw holes fig. # 5 stop of refrigerator door (Not on all Models) middle bracket (central hinge bracket) 5. To install freezer door: make the left bottom hole of freezer door fall over the central hinge axle; raise upper hinge, so that hinge axle can be installed in the upper hole of the upper part of the freezer door; adjust door to make it straight and level. 1, install the upper freezer hinge to the left corresponding position. Replace the hinge cover as shown in Fig. [. . . ] Do not exceed the 15 watts rating at any time. To replace cover, insert rear clips in first and gently push front clip in until the cover snaps into place. Power Interruptions · Occasionally there may be power interruptions due to thunderstorms or other causes. Remove the power cord from AC outlet when a power outage occurs. When power has been restored, replug power cord to AC outlet. [. . . ]