User manual HAIER HW-07LF03

[. . . ] If the supply cord is damaged, it must be replaced by the manufacturer or its serviceagent or a similar qualified person. After installation, the power plug should be easily reached. The wiring method should be in line with the local wiring standard. 2 Parts Name Machine body Front panel Air inlet (indoor side) Machine body Air outlet (indoor side) Air inlet (outdoor side) Display panel Power plug Air filter (inside) Operation panel 3 Operation Guide Auto swing switch When the switch is set to " ", the indicator lights up, and vertical louvers will swing from side to side, delivering gentle air thus making you feel very comfortable. [. . . ] Block the bottom plate hole of the conditioner with rubber lid, install outlet pipe fitting on the back hole and let the condensing water flow from the back hole of the conditioner. (See Fig. 1 ) In this method, the accumulated condensed water in the bottom plate is hit by the fan onto the heat exchanger, and evaporated and blown out from the machine. It can cool the heat exchanger radiator more quickly, and improve the energy efficiency of the conditioner. But the hitting noise by the fan at the outdoor side is relatively large. Block the back hole of the conditioner with rubber lid and install outlet pipe fitting to the bottom hole, which can make the condensed water flow out from the bottom plate. (See Fig. 2) If necessary the above two methods can both have extra pipe added on the outlet pipe fitting. (available on the market). (Refer to P12 for choosing these two modes. ) Fig. 1 Fig. 2 Outlet pipe fitting Rubber lid Back hole Rubber lid Bottom plate hole Back hole Outlet pipe fitting Bottom plate hole Cautions Power cord: Be sure to use the exclusive power cord. Change installation place: If air-con need to be changed to another place please contact the dealer, who sold you the unit. 7 Maintenance Avoid opening doors and windows unless necessary. Don't be exposed to cold air for a long time. Use curtain or blind Direct sunlight may reduce cooling effect, always use window curtain. Keep heat source away from air conditioner. Set temp . a little bit higher before going to bed. After unit stops, don't restart it until 3 min. have elapsed. Proper temperature OK!Enjoy a 3-min nap 8 Troubleshooting Readjust power supply. Replace fuse. Doesn't work Is plug firmly inserted?Readjust the thermostat. Does fuse get burned? Use curtain or blind. Is thermostat switch wrongly adjusted? No cool air or poor cooling Shut doors and windows. Is there any direct sunlight in the room?Are there any obstacles blocking air inlet and outlet? Is air filter clogged?Remove the heat source Is there too much heat source in the room? [. . . ] If the surrounding humidity is high, should assemble drainage bend in the drainage hole at the back of bottom plate and connect the drainage tube as Rubber lid illustrated in Fig. If the user doesn't need to Drain pan retain the condensate in the bottom plate, can Screw remove the rubber lid on the bottom and as illustrated in Fig. 2 pan on the bottom of the air-conditioner, and connect drainage tube at the water outlet hole on the drain pan. Condenser 5. [. . . ]